Zanussi ZDT41 manual Setting and starting a washing programme, Use of detergent tablets

Page 10

3

4

Fill the detergent dispens-

If you use a washing pro-

er (A) with detergent.

gramme with prewash

 

phase, put more detergent

 

in the prewash detergent

 

compartment (B).

56

Use of detergent tablets

Put the detergent tablet in the detergent dispenser (A). Detergent tablets contain:

detergent

rinse aid

• other cleaning agents.

Do these steps to use detergent tablets:

1.Make sure that the detergent tablets are applicable for your water hardness. Refer to the instructions from the manufacturer.

2.Set the lowest levels of water hardness and rinse aid dosage.

It is not necessary to fill the salt container and the rinse aid dispenser.

Do these steps when the drying results are not satisfactory:

1.Fill the rinse aid dispenser with rinse aid.

2.Set the rinse aid dosage to position 2.

Do these steps to use the detergent powder again:

1.Fill the salt container and the rinse aid dispenser.

2.Set the water softener to the highest level.

3.Do a washing programme without dishes.

4.Adjust the water softener. Refer to the chapter 'Setting the water softener'.

5.Adjust the rinse aid dosage.

Different brands of detergent dissolve in different times. Some detergent tablets do not have the best

cleaning results during short washing programmes. Use long washing programmes when you use detergent tab- lets to fully remove the detergent.

Setting and starting a washing programme

Set the washing programme with the door ajar. The washing programme only starts after you close the

door. Until then it is possible to modify the settings. Do these steps to set and start a washing programme:

1.Switch on the appliance.

2.Make sure that the appliance is in setting mode.

3.Press the programme selection/cancel button again and again to set the washing programme. Refer to the chapter 'Washing programmes'.

The programme indicator light comes on.

4.Close the door.

The washing programme starts automatically.

When the washing programme operates, you cannot change the programme. Cancel the washing pro-

gramme.

Warning! Only interrupt or cancel a washing programme if necessary.

Caution! Open the door carefully. Hot steam can come free.

Cancelling a washing programme

1.Press and hold the programme selection/cancel but- ton for approximately 3 seconds.

The programme indicator light goes off.

The end indicator light starts to flash.

10

Image 10
Contents ZDT41 Contents Safety informationIndicator light Programme selection/cancel buttonContact your local Service Force Centre Control panelAudible signals Setting modeProgramme indicator lights a and B Washing programmesUse of the appliance Setting the water softenerConsumption values Water hardness setting Manually Manual adjustmentElectronic adjustment Use of dishwasher saltImportant! Fill the salt container from time to time Use of rinse aidDo these steps to fill the rinse aid dispenser Loading cutlery and dishes Adjusting the dosage of rinse aidHelpful hints and tips Upper position Use of detergentMaximum height of the dishes Lower positionCancelling a washing programme Setting and starting a washing programmeDo these steps when the drying results are not satisfactory Use of detergent tabletsInterrupting a washing programme Care and cleaningCleaning the filters End of the washing programmeFault code and malfunction External cleaningFrost precautions Possible cause and solutionCleaning results are not satisfactory Technical dataEnvironment concerns Water connection InstallationAdjusting the level of the appliance Water inlet hoseElectrical connection 156985570-00-042009