2.Release the programme selection/cancel button to cancel the washing programme.
At this time you can do these steps:
1.Switch off the appliance.
2.Set a new washing programme.
Fill the detergent dispenser with detergent before you set a new washing programme.
Interrupting a washing programme
Open the door.
•The programme stops. Close the door.
•The programme continues from the point of interrup- tion.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
•The audible signals for the end of the programme op- erate.
1.Open the door.
–The end indicator light comes on.
–The programme indicator light stays on.
2.Press the on/off button.
3.For better drying results, keep the door ajar for some
minutes before you remove the dishes.
Let the dishes cool down before you remove them from the appliance. Hot dishes are easily damaged.
Removing the load
•First remove items from the lower basket, then from the upper basket.
•There can be water on the sides and door of the appli- ance. Stainless steel becomes cool more quickly than the dishes.
Care and cleaning
Warning! Switch the appliance off before you clean the filters.
Cleaning the filters
Important! Do not use the appliance without the filters. Make sure that the installation of the filters is correct. Incorrect installation will cause unsatisfactory washing results and damage to the appliance.
12
Fully clean the filters A, B and C below running wa- ter.
3
To remove filters B and C, turn the handle approxi- mately 1/4 anticlockwise.
5
Put the flat filter A in the bottom of the appliance. Install the flat filter cor- rectly under the two guides D.
4
Remove the flat filter A from the bottom of the ap- pliance.
6
Put the filter system in po- sition. To lock the filter system, turn the handle clockwise until it locks in position.
11