Zanussi ZKC6040 user manual Ensure that the cover is securely fastened

Page 36

•We recommend you use a new length of 6mm2 twin core earthed cable to ensure your safety.

•Make connection by proceeding as follows: -

•When refitting the mains terminal cover, ensure that the lower tabs are located inside the bottom edge of the aperture, before fixing the two screws into the top edge of the mains terminal cover.

L L N N N

Note: Blanking plates not to be removed.

Ensure that the links are fitted as shown

•Pre-form wires to the appropriate shape to suit fitting into the mains terminal block.

•Strip inner insulation on wires using wire strippers.

•Twist the bared wires using pliers.

•Cut bared wires 10mm away from the end of the inner insulation.

•Where uninsulated Earth wires are used ensure they are suitably sheathed to leave 10mm bare wire to fit into the terminal.

•Clamp bare wires into the relevant terminal and check they are held by tugging each one in turn.

•Ensure all screws are securely tightened.

•Clamp the mains cable securely ensuring 5mm of the outer insuation is inside the terminal block and that the wires are not taut but not so slack as to cause any fouling.

•Connect the remaining end of the mains cable to the appliance to the appliance point / junction box.

•Place fuse / miniature circuit breaker in circuit and switch on at mains.

36

•Ensure that the cover is securely fastened.

Note: House circuit

Earth leakage / continuity tests must be carried out before the appliance is connected to the mains supply and re-checked after fitting.

Image 36

Contents User Manual Cooker Contents Important safety instructions InstallationChild safety During useCleaning and maintenance Extreme care must be taken when using a ceramic hob scraperProduct description Controls and their functionsBefore using the appliance Rating plateCondensation and steam CookwareGrill and oven furniture Electronic timer To set the time of dayTo set the countdown To cancel the countdown Countdown indicatorPress the selector Neon flashesTo set the timer to switch on and off automatically That the correct time of day is displayedTo set the timer to switch off only Cook time indicator Indicator neon will Controls Continue to flash for aCook time Return to the time DayUsing the hob Hints and tips when using the hobHob Recommended saucepansHot hob indicator Using the grillGrill settings are as follows GrillGrill pan and handle To Remove. PressButton on Slide the handle Towards the rightGrilling chart Hints and tipsFood should be turned over during cooking as required Using the top oven Top ovenTo fit the top oven shelf Hints and tips Main oven Things to note Oven cooking chart Oven cooking chart Roasting chart 160 180 CUsing defrost DefrostUsing main oven light Using top oven lightMain oven light Top oven lightUsing slow cook Slow cookFood preparation slow cooking General pointsThaw thoroughly before cooking Care and cleaning To reduce marking of the hob Avoid the useCleaning the doors Aerosol cleaners must not be used on Stay- clean surfacesInner door glass is removable for cleaning Household detergents and bleachesTo remove the glass To replace the door glassTop Oven Main OvenReplacing an oven light bulb Type of bulb required is a 300C 25 watt small Edison ScrewTroubleshooting Timer does not work Oven is not cooking evenlyOven light fails to illuminate Oven fan is noisy Installation instructions Connecting to the electricity supplyThis appliance must be earthed Ensure that the cover is securely fastened Ensure all screws are securely tightenedTechnical data Energy save modeSwitching off the time display Switching on the time displayGuarantee / Customer care Standard guarantee conditionsPage 349143001