Sherwood RX-773 manual Connecting MULTI-ROOM System KIT, Switched AC Outlet, AC Input Cord

Page 7

6. CONNECTING MULTI-ROOM SYSTEM KIT

• The multi-room system kit(sold separately ) is essential for operation from a remote location .

For information on the multi-room system kit, contact the Xantech corporation at 1-800-843-5465 or www.xantech.com.

•IR IN jack allows you to control this receiver from another room with the remote control unit.

•To control this receiver from another room with the remote control unit, connect the IR IN jack to the output of the connecting block.

•If this receiver is located inside a cabinet or other enclosure where the infrared beams from the remote control unit cannot enter, then operation with the remote control unit will not be possible. In such a case, connect the IR IN jack to the output of the connecting block.

•To control other compatible component from another room with the universal remote control unit, connect the IR OUT jack to the IR emitter.

Note: Remote operation may become unreliable if the IR receiver is exposed to strong light such as direct sunlight or inverted fluorescent.

7. SWITCHED AC OUTLET

•This outlet is switched on (power-on mode) and off (standby mode) according to power control as follows (Maximum total capacity is 100 W (0.43A)).

Standby mode - Switched AC outlet off

Power - on mode - Switched AC outlet on

8. AC INPUT CORD

• Plug the cord into an wall AC outlet.

ENGLISH

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Page Read this Before Operating Your Unit For Your SafetyPAN-EUROPEAN Unified Voltage Contents System Connections Connecting AntennasConnecting Line OUTs Connecting Audio ComponentsConnecting PC for Upgrades Connecting SpeakersSwitched AC Outlet Connecting MULTI-ROOM System KITAC Input Cord Fluorescent Display Front Panel ControlsRemote Sensor AUX 1, 2 in Jacks Bluetooth in ConnectorUniversal Remote Controls Function Table of the Numbered Buttons Loading Batteries Remote Control Operation RangeEntering a setup code Using Functions of Remote ControlRemoving a punch-through function Using a punch-through functionOperating a macro function Programming a macro functionTo remove a macro program To change a macro programListening to a Program Source OperationsBefore operation BT-IN CD Tape DVD AUX Tuner Phono AUXAdjusting the sound volume balance Adjusting the tone bass and trebleListening to Radio Broadcasts Auto tuningManual tuning Auto presettingMemory Backup Function Manual presettingTuning to preset stations RDS Srch TP Srch PTY Srch OFF Listening to RDS Broadcasts FM onlyRDS search TP searchDisplay PTY searchNEWS, AFFAIRS, INFO, SPORT, EDUCATE, Drama Other Functions Operating the sleep timerAdjusting the brightness of the fluorescent display RecordingTuner Phono AUX BT-IN CD Tape DVD ROOM2 PlaybackEnglish Possible Cause Remedy Troubleshooting GuideAM Tuner Section SpecificationsAmplifier Section FM Tuner SectionSetup Code Table McMICHAEL SEI Seleco Sharp Sambers Sampo Samsung Sanyo SBR Schaub Lorenz Schneider SEGEnglish RCA Thomson THORN- FergusonABC NSCSAT Optimus SherwoodKenwood Magnavox
Top Page Image Contents