ENGLISH
Operations
LISTENING TO A PROGRAM SOURCE
Before operation
• Push the POWER switch.
• This unit enters the standby mode and the POWER ON/STANDBY button lights up amber.
This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the operation readiness.
• To switch the power off, push the POWER switch again. Then the power is cut off and the POWER ON/STANDBY button goes off.
1. In the standby mode, turn the power on.
| • Each time the POWER ON/STANDBY button on the front |
| panel is pressed, the receiver is turned on to enter the |
| operating mode(the POWER ON/STANDBY button lights |
| up blue) or off to enter the standby mode(the POWER |
| ON/STANDBY button lights up amber). |
| • On the remote control, press the POWER ON button to |
or | enter the operating mode or press the STANDBY button |
| to enter the standby mode. |
2. Switch the desired speakers on.
| • You can select the various combinations of speakers | |||
| depending on where the speakers C or/and D are | |||
| installed. |
|
|
|
| • Each time the SPEAKER A/B SELECTOR button on the | |||
or | front panel is pressed, the speakers are switched on or off | |||
as follows: |
|
|
| |
| A/B ~ | A/ - ~ | ||
| or (MAIN A/B) | or (MAIN | or (MAIN | or |
| ( ): When the ROOM2 mode is set to on. |
| ||
•Each time the SPEAKER C/D SELECTOR button on the front panel is pressed, the speakers are switched on or off as follows:
| ~C/D | ~ | ~ C/ - | ~ |
|
|
| ||||
| or (R2 C/D) | or (R2 | or (R2 | or (R2 | |
|
|
|
|
|
|
( ): When the ROOM2 mode is set to on.
• When using the headphones for private listening, switch off all the speakers installed in the main room.
Note: To use ROOM2 function, you should install speakers C or/and D in another room (ROOM2) and set the ROOM2 mode to on.(For details, refer to “CONNECTING SPEAKERS” on page 6 and “ROOM2 PLAYBACK” on page 24.)
16