Onkyo HT-RC460 Connecting the AV Receiver, En-11, Connecting Your Speakers, Connections

Models: HT-RC460

1 140
Download 140 pages 59.79 Kb
Page 11
Image 11
Connecting the AV Receiver

Connecting the AV Receiver

Connecting Your Speakers

Speaker Configuration

The following table indicates the channels you should use depending on the number of speakers that you have.

No matter how many speakers you use, a powered subwoofer is recommended for a really powerful and solid bass.

To get the best from your surround sound system, you need to set the speaker settings automatically (page 32) or manually (page 50).

Number of speakers

2 3 4 5 6

7

7

Front speakers

✔ ✔ ✔ ✔ ✔

 

 

 

 

Center speaker

✔ ✔ ✔

 

 

Surround speakers

✔ ✔ ✔ ✔ ✔

 

 

 

 

Surround back speaker*1*2

 

 

Surround back speakers*2

 

 

Front high speakers*2

 

 

Connections

Surround Surround

right left

Surround back/

Surround back/

Front right

Front left

Center

Front high

Front high

 

 

 

right

left

 

 

 

*1 If you’re using only one surround back speaker, connect it to

the SURROUND BACK or FRONT HIGH L terminals.

*2 Front high and surround back speakers cannot be used at the same time.

Connecting the Speaker Cables

The following illustration shows how to connect the speakers to each pair of terminals. If you’re using only one surround back speaker, connect it to the SURROUND BACK or FRONT HIGH L terminals.

Tip

You can specify whether surround back or front high speakers are connected in the “Speaker Configuration” menu (page 50) or during Audyssey 2EQ® Room Correction and Speaker Setup (page 32).

Screw-type speaker terminals

Strip 1/2" to 5/8" (12 to 15 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown.

1/2" to 5/8" (12 to 15 mm)

Push-type speaker terminals

Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown.

3/8" to 1/2"(10 to 12 mm)

Banana Plugs

If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.

Do not insert the speaker code directly into the center hole of the speaker terminal.

En-11

Page 11
Image 11
Onkyo HT-RC460 Connecting the AV Receiver, En-11, Connecting Your Speakers, Connections, Screw-typespeaker terminals