Frigidaire FPHG2399MF, FGUS2647LF, FGUS2632LE, FGUN2642LP, FGUS2632LP manual Installing Door Handles

Page 11

INSTALLING DOOR HANDLES

Door Handle Mounting Instructions for Frigidaire Gallery®

1Remove handles from carton and any other protective packaging.

2Position fresh food handle end over upper and lower pre-installed shoulder bolts (A) that are fastened into door, ensuring the holes for the set screws are facing towards the opposite door.

3While holding handle firmly against door, fasten upper and lower Allen set screws (B) with supplied Allen wrench.

4Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are facing towards the first door.

5Position freezer handle end over left and right pre-installed handle mounts that are fastened to the door, ensuring the holes for the set screws are facing down.

6While holding handle firmly against door, loosely tighten far right Allen set screw (B) with supplied

Allen wrench until there is no gap between handle and door.

7Still holding the handle firmly to the door, firmly tighten far left Allen set screw (B) with supplied Allen wrench.

8Return to the far right Allen set screw (B) and firmly tighten with supplied Allen wrench.

Mounting Refrigerator Handles

NOTE

All set screws should be tightened so the screw is below the surface of the handle. The handles should be drawn tight to freezer and refrigerator doors with no gaps. Opening the opposite door while tightening the Allen screw makes installation easier.

The door handle may loosen over time or if it was installed improperly. If this happens, tighten the set screws on the handles.

Mounting Freezer Handle

CAUTION

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.

11

Image 11

Contents Use &Care Important Safety Instructions Electrical information Features may vary according to model Features AT a GlanceLocation InstallationInstallation Required ToolsDoors if necessary Level Refrigerator & AdjustTo level the cabinet using the front rollers select models Leveling Freezer Drawer if necessaryEnsure door stops in desired location To adjust the door stopDoor stop is adjustable between 85 to 145 degrees Retighten screwLoosen the screw located on the flipper mullion hinge To adjust the flipper mullionTo remove the top hinge covers Door Removal InstructionsGetting through narrow spaces To prepare for removing the doorsOpen freezer drawer Installing Freezer DrawerRemoving Freezer Drawer Door Handle Mounting Instructions for Frigidaire Gallery Installing Door HandlesMounting Refrigerator Handles Before Installing The Water Supply Line, You Will Need Connecting the Water SupplyTo Connect Water Supply Line To Ice Maker Inlet Valve IQ-TouchTM AlarmsControls IQ-TouchTMSabbath Mode Automatic ICE Maker select models Crispers Storage FeaturesShelf features DrawersDeli drawer Accessories varies by model Dairy compartmentFreezer Features varies by model To change the position of an adjustable door binDividers Removal To Remove Upper BasketTo Remove Lower Basket Storing Food and Saving Energy Understanding the sounds you may hear Normal Operating Sounds and SightsChanging the Filter Replacing your PureAdvantageTM air filter Air Filter Reset will turn itself off after a few secondsAir Filter Replacement cartridge, Paultra Air filter select modelsProtecting your investment Care & CleaningGone a few days Care and cleaning tipsVacation and moving tips Replacing Light Bulbs select models Ordering Replacement LED LightsReplacing LED Lights select models To replace LED LightsUnited States Canada Before YOU CallRuns too much CompressorDoes not run RefrigeratorExclusions This warranty does not cover the following Major Appliance Warranty