Frigidaire FGUN2642LF manual Leveling Freezer Drawer if necessary, Level Refrigerator & Adjust

Page 6

INSTALLATION

Leveling Freezer Drawer (if necessary)

1Check gasket seal around top, bottom, and sides of freezer drawer.

2If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate.

3Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.

Remove	Remove
hex	hex
head	head
drawer	drawer
screw	screw
	Do Not Remove
	Other Screws
Remove	Remove
Hex	Hex
Head	Head
Drawer	Drawer
Screw	Screw

4Tighten four (4) drawer screws.

5 Recheck gasket seal.

To level the cabinet using the front rollers (select models):

1Slightly open freezer drawer. Lift the toe grille and gently pull forward (see illustration).

2You can raise or lower each door. Use a 3/8 inch socket wrench to turn the adjustment screws (1 per side).

Toe Grille Must

Fit in Slot On

Anti-tip Bracket

Screw/Washer

Assembly

(3) Retaining Clips

To raise: turn adjustment screw clockwise.

To lower: turn adjustment screw counterclockwise.

3Ensure both doors are bind-free with their seals touching the cabinet on all four sides and that cabinet is stable.

4After unit is leveled, lower anti-tip leg until it contacts the floor.

Push	Grab
Against	Drawer
Freezer	at
Drawer	Center
	from
	Both
	Sides
	then
	Pull
	Drawer
	Out
A	B

Level Refrigerator & Adjust

Door

Door

Raise

Doors (if necessary)

Guidelines for final positioning of your refrigerator:

•All four corners of the cabinet must rest firmly on the floor.

•The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly).

•Doors should align with each other and be level.

Most of these conditions can be met by raising or lowering the adjustable front rollers.

Anti-tip

Leg

Lower

5Install the toe grille by fitting into place.

6

Image 6

Contents Use &Care Important Safety Instructions Electrical information Features AT a Glance Features may vary according to modelRequired Tools InstallationInstallation LocationLeveling Freezer Drawer if necessary Level Refrigerator & AdjustTo level the cabinet using the front rollers select models Doors if necessaryRetighten screw To adjust the door stopDoor stop is adjustable between 85 to 145 degrees Ensure door stops in desired locationTo adjust the flipper mullion Loosen the screw located on the flipper mullion hingeTo prepare for removing the doors Door Removal InstructionsGetting through narrow spaces To remove the top hinge coversInstalling Freezer Drawer Removing Freezer DrawerOpen freezer drawer Installing Door Handles Door Handle Mounting Instructions for Frigidaire GalleryMounting Refrigerator Handles Connecting the Water Supply Before Installing The Water Supply Line, You Will NeedTo Connect Water Supply Line To Ice Maker Inlet Valve Alarms ControlsIQ-TouchTM IQ-TouchTMSabbath Mode Automatic ICE Maker select models Drawers Storage FeaturesShelf features CrispersTo change the position of an adjustable door bin Accessories varies by model Dairy compartmentFreezer Features varies by model Deli drawerTo Remove Upper Basket To Remove Lower BasketDividers Removal Storing Food and Saving Energy Normal Operating Sounds and Sights Understanding the sounds you may hearChanging the Filter Air filter select models Air Filter Reset will turn itself off after a few secondsAir Filter Replacement cartridge, Paultra Replacing your PureAdvantageTM air filterCare & Cleaning Protecting your investmentCare and cleaning tips Vacation and moving tipsGone a few days To replace LED Lights Ordering Replacement LED LightsReplacing LED Lights select models Replacing Light Bulbs select modelsBefore YOU Call United States CanadaRefrigerator CompressorDoes not run Runs too muchMajor Appliance Warranty Exclusions This warranty does not cover the following