Frigidaire FGUS2647LF, FGUS2632LE, FGUN2642LP, FGUS2632LP, FGUS2645LF Mounting Refrigerator Handles

Page 12

INSTALLING DOOR HANDLES

Door Handle Mounting Instructions for Frigidaire Professional®

1Remove handles from carton and any other protective packaging.

2Position fresh food handle end over upper and lower pre-installed shoulder bolts (A) that are fastened into door, ensuring the holes for the set screws are facing towards the opposite door.

3While holding handle firmly against door, fasten upper and lower Allen set screws (B) with supplied Allen wrench.

4Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws are facing towards the first door.

5Position freezer handle end over left and right pre-installed handle mounts that are fastened to the door, ensuring the holes for the set screws are facing down.

6While holding handle firmly against door, loosely tighten far right Allen set screw (B) with supplied

Allen wrench until there is no gap between handle and door.

7Still holding the handle firmly to the door, firmly tighten far left Allen set screw (B) with supplied Allen wrench.

8Return to the far right Allen set screw (B) and firmly tighten with supplied Allen wrench.

9Firmly tighten the inside Allen set screws.

Mounting Refrigerator Handles

NOTE

All set screws should be tightened so the screw is below the surface of the handle. The handles should be drawn tight to freezer and refrigerator doors with no gaps. Opening the opposite door while tightening the Allen screw makes installation easier.

The door handle may loosen over time or if it was installed improperly. If this happens, tighten the set screws on the handles.

Mounting Freezer Handle

12

CAUTION

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.

Image 12

Contents Use &Care Important Safety Instructions Electrical information Features AT a Glance Features may vary according to modelInstallation InstallationRequired Tools LocationLevel Refrigerator & Adjust To level the cabinet using the front rollers select modelsLeveling Freezer Drawer if necessary Doors if necessaryTo adjust the door stop Door stop is adjustable between 85 to 145 degreesRetighten screw Ensure door stops in desired locationTo adjust the flipper mullion Loosen the screw located on the flipper mullion hingeDoor Removal Instructions Getting through narrow spacesTo prepare for removing the doors To remove the top hinge coversInstalling Freezer Drawer Removing Freezer DrawerOpen freezer drawer Installing Door Handles Door Handle Mounting Instructions for Frigidaire GalleryMounting Refrigerator Handles Connecting the Water Supply Before Installing The Water Supply Line, You Will NeedTo Connect Water Supply Line To Ice Maker Inlet Valve Alarms ControlsIQ-TouchTM IQ-TouchTMSabbath Mode Automatic ICE Maker select models Storage Features Shelf featuresDrawers CrispersAccessories varies by model Dairy compartment Freezer Features varies by modelTo change the position of an adjustable door bin Deli drawerTo Remove Upper Basket To Remove Lower BasketDividers Removal Storing Food and Saving Energy Normal Operating Sounds and Sights Understanding the sounds you may hearChanging the Filter Air Filter Reset will turn itself off after a few seconds Air Filter Replacement cartridge, PaultraAir filter select models Replacing your PureAdvantageTM air filterCare & Cleaning Protecting your investmentCare and cleaning tips Vacation and moving tipsGone a few days Ordering Replacement LED Lights Replacing LED Lights select modelsTo replace LED Lights Replacing Light Bulbs select modelsBefore YOU Call United States CanadaCompressor Does not runRefrigerator Runs too muchMajor Appliance Warranty Exclusions This warranty does not cover the following