Setting the hob for the new gas type
1.If necessary, activate the hob by touching
the main ON/OFF Control 
for about 3 seconds.
2.Touch the Timer Control 
repeatedly to select the auxiliary burner (front left burner) on the burner selection display .
3.Touch the Increasing Control 
and hold the finger on it until the value 99 appears on the time display. Then, touch the
Decrasing Control 
and hold the finger on it until the value 80 is displayed.
4.Then, touch the Increasing Control 
until 83 is displayed. At this point, the hob is set to the “Gas Change” mode and the current gas setting appears on the display:
-n0 stands for gas G20 (20 mbar)
-n1 for gas G30
IMPORTANT: setting n2 does not allow the hob to function.
33