Electrolux 318201775 When All Hookups are Complete, Before You Call for Service

30" GAS RANGE INSTALLATION INSTRUCTIONS

6.Operation of Oven Burners and Oven Adjustments

6.1 Electric Ignition Burners

Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks, and range has been connected to electric power.

The oven burner is equipped with an electric control system as well as an electric oven burner igniter. If your model is equipped with a waist-high broil burner igniter, it will also have an electric burner igniter. These control systems require no adjustment. When the oven is set to operate, current will flow to the igniter. It will "glow" similar to a light bulb. When the igniter has reached a temperature sufficient to ignite gas, the electrically controlled oven valve will open and flame will appear at the oven burner. There is a time lapse from 30 to 60 seconds after thermostat is turned ON before the flame appears at the oven burner. When the oven reaches the display setting, the glowing igniter will go off. The burner flame will go "out" in 20 to 30 seconds after igniter goes "OFF". To maintain any given oven temperature, this cycle will continue as long as the display is set to operate.

After removing all packing materials and literature from the oven:

a)Set the oven to BAKE at 300°F. See Use & Care Guide for operating instructions.

b)Within 60 seconds the oven burner should ignite. Check for proper flame (see 6.2), and allow the burner to cycle once (see cycle explanation above). Reset controls to off.

c)If your model is equipped with a waist-high broiler burner, set oven to broil. See Use & Care Guide for operating instructions.

d)Within 60 seconds the broil burner should ignite. Check for proper flame (see 6.3). Reset controls to off.

6.2 Oven Burner Flame Adjustment

The approximate oven burner flame length is 1 inch (distinct inner cone of blue flame).

To determine if the oven burner flame is proper, remove the oven bottom and burner baffle and set the oven to bake at 300°F.

To remove the oven bottom, remove oven hold down screws at rear of oven bottom. Pull up at rear, disengage front of oven bottom from oven front frame, and pull the oven bottom out of the oven. Remove burner baffle so that burner flame can be observed.

If the flame is yellow, increase air shutter opening size (see "2" in Figure 12). If the entire flame is blue, reduce the air shutter opening size.

To adjust flame loosen lock screw (see "3" in Figure 12), reposition air shutter, and tighten lock screw. Replace oven bottom.

Oven Burner Tube

3Lock Screw

2 Air Shutter

1 Orifice Hood

Figure 12

6.3 Broil Burner Flame Adjustment

The approximate flame length of the burner is 1 inch (distinct inner cone of blue flame). To determine if the broil burner flame is proper, set the oven to broil. If flame is yellow, increase air shutter opening size (see "2" in Figure 12 ). If the entire flame is blue, reduce the air shutter opening size. To adjust, loosen lock screw (see "3" in Figure 12), reposition air shutter, and tighten lock screw.

Lower

Oven Burner

Baffle

(removable)

Figure 11

Waist-High Burner Air Shutter

Lower Oven Bottom Air Shutter (removable)

When All Hookups are Complete

Make sure all controls are left in the OFF position.

Before You Call for Service

Read the Before You Call for Service Checklist and operating instructions in your Use and Care Guide. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

Refer to your Use and Care Guide for Electrolux Service phone numbers, or call 1-877-4ELECTROLUX(1-877-435-3287).

8