30" GAS RANGE INSTALLATION INSTRUCTIONS
Important Safety Warning
To reduce the risk of tipping of the range, the range must be secured to the floor by the properly installed
These parts are located in a plastic bag in the oven. 30" Range has one bracket. Failure to install the bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it. Serious injury might result from spilled hot liquids or from the range itself.
Follow the instructions below to install the
If range is ever moved to a different location, the anti- tip bracket must also be moved and installed with the range.
Tools Required:
5/16" (8 mm) Nut driver or Flat Head Screwdriver Adjustable Wrench
Electric Drill
3/16" (4.8 mm) Diameter Drill Bit
3/16" (4.8 mm) Diameter Masonry Drill Bit (if installing in concrete)
Anti-Tip Bracket Installation
1.The
2.The
3.Unfold paper template and place it flat on the floor with the back and side edges positioned exactly where the back and sides of range will be located
when installed. (Use the diagram in figure 13 to locate bracket if template is not available.)
4.Mark on the floor the location of the mounting holes shown on the template (right and left position). For easier installation, 3/16" (4.8 mm) diameter pilot holes 1/2" (1.3 cm) deep can be drilled into the floor.
5.Remove template and place bracket on floor (see figure 13). Line up holes in bracket with marks on floor and attach the bracket using the screws provided. Brackets must be secured to solid floor. If attaching to concrete floor, first drill 3/16" (4.8 mm) dia. pilot holes using a masonry drill bit.
6.Level range if necessary, by adjusting the 4 leveling legs with an adjustable wrench. Loosen the screw which fixes the decorative leg and lift it to reach the leveling leg. Turn the leveling leg counterclockwise to raise the range or clockwise to lower the range (see Figure 14). Replace the decorative legs at your convenience.
7.Before sliding the range to its final position; take note of the serial and model numbers for future reference. Slide range into place making sure rear leg is trapped by the bracket. Range may need to be shifted slightly to one side as it is being pushed back to allow rear leg to align with bracket.
8.After installation, visually verify that the
engaged.
Wall | B |
|
A
A B | Center |
| |
Wall | Line | ||
| |||
|
|
Figure 13
30" range: Install the
| Base | of Range |
|
| |
Leveling |
| Decorative |
Leg |
| |
| Leg Screw | |
|
| |
Raise |
|
|
Lower |
|
|
|
| Figure 14 | |
|
|
|
|
| A |
| B |
30" Range | 11 5/16 (28.7 cm) |
| 2 1/2 (6.4 cm) |
|
|
|
|
9