Frigidaire 316423411 Adjusting Your Oven Temperature, To replace the oven light bulb

Page 18

General Care & Cleaning (cont’d)

Changing the Oven Light (some models)

The oven light automatically turns ON when the door is opened. The oven light may also be manually operated by pressing the oven light switch located on top of the control panel. The oven light bulb is located at the rear of the oven and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.

To replace the oven light bulb:

1. Turn electrical power off at the main source or unplug the range.

2. Press wire holder to one side to release the glass shield.

3. Replace bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder into place.

5. Turn power back on again at the main source (or plug the range back in).

6. The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Manual.

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

Care & Cleaning of Stainless Steel (some models)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the Cleaning Table at the beginning of this section for detailed cleaning instructions.

Adjusting Your Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1.Press .

2.Set the temperature to 550°F (287°C) by pressing and holding the .

3.Within 2 seconds, press and hold until the 2 digit display appears. Release . The display now indicates the amount of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."

4.The temperature can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the or . Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5.When you have made the desired adjustment, press to go back to the time of day display.

Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

Circuit Protection (Models with electric outlets)

As a protection against surcharge, a 15 amp, 20 volt breaker is provided for each of the electric outlets (1 max.) located on top or underneath of the control panel. Models with no electric outlet have no breaker. Press to reset.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Before You Call Features at a Glance Before Setting Oven ControlsAdjusting Oven Temperature WelcomeImportant Safety Instructions Welcome & CongratulationsProduct Registration Important Instructions for Using Your Cooktop Important Instructions for Usingyour Cooktop Cont’d When flaming foods under a ventilating hood, turn the fan onFeatures At a Glance Your Electric Range Features IncludeBefore Setting Oven Controls Suggested Radiant Surface Element Settings Table Setting Surface ControlsUsing proper cookware Cookware Material TypesAbout the Radiant Surface Elements Setting Surface Controls cont’dElement on & Hot Surface Indicator Lights Single Radiant Surface Elements all modelsSetting the Warming Zone some models Setting the Warming Zone ControlSurface areas that heat are shown in black Oven Control Functions Setting Oven ControlsTemperature conversion For a silent control panelTo Set or Change the Temperature for Baking Setting Oven Controls cont’d To Set the ClockTo Set the Minute Timer To Set Control for Continuous Bake or 12 Hour Energy SavingSpeed Bake Cooking System some models How Speed Bake Cooking System worksSpeed Bake Cooking Instructions Self-Cleaning Setting Oven Controls cont’dTo Set Speed Bake Cooking System Self-Cleaning cont’d Preparing for a Self-Clean Cycle Adhere to the following cleaning precautionsWhen the Self-Clean Cycle has Completed General Care & Cleaning Stainless SteelPlastic or foods with a high sugar content For heavy, burned on soilTo Remove Oven Door Special Caution for Aluminum Use on the Ceramic CooktopRemoving & Replacing the Lift-Off Oven Door To Replace Oven DoorTo Adjust Oven Temperature Adjusting Your Oven TemperatureCare & Cleaning of Stainless Steel some models Circuit Protection Models with electric outletsSolutions to Common Problems Before You CallMajor Appliance Warranty Information Exclusions This warranty does not cover the following

316423411 specifications

The Frigidaire 316423411 is a highly regarded oven bake element, designed to ensure efficient cooking and baking in various culinary settings. This component is widely compatible with several Frigidaire models, allowing users to replace old, malfunctioning elements with ease and confidence.

One of the main features of the Frigidaire 316423411 is its robust construction, which comprises durable materials that can withstand high temperatures. This durability ensures that the element can deliver consistent heating performance over time, reducing the likelihood of warping or breaking under stress.

The heating element itself has a power rating that typically falls around 2600 watts, which provides rapid heating capabilities. This power allows users to achieve high temperatures quickly, making it ideal for baking, roasting, and broiling. Consumers appreciate this feature as it saves both time and energy during meal preparation.

In addition to its impressive heat output, the Frigidaire 316423411 boasts even heat distribution. This technology ensures that food is cooked evenly, minimizing the risk of hot or cold spots. Home cooks can rely on this feature to achieve perfectly baked goods, such as cakes and cookies, while also ensuring that meats and vegetables are cooked thoroughly.

Another characteristic of the Frigidaire 316423411 is its user-friendly installation process. Most users can replace the element without requiring professional assistance. Detailed instructions provided with the product guide users through the installation steps, often requiring only basic tools and safety precautions.

The element is also designed with safety features that prevent overheating, thereby reducing the risk of kitchen accidents. Users can rest assured knowing that they have a reliable and safe component in their oven.

Overall, the Frigidaire 316423411 is a pivotal part of modern baking technology. Its combination of durability, efficient heating, even heat distribution, and user-friendly installation makes it an essential component for anyone looking to enhance their cooking experience. Whether you are an experienced chef or a novice baker, this element is sure to meet your cooking needs and contribute to delicious meals.
Top Page Image Contents