Frigidaire CGGF3054KF, 316901300 Setting Surface Controls, Setting surface controls, Home Canning

Page 11

Setting surface controls

Your gas range may be

 

equipped with many

 

different sized surface

 

burners. The ability to heat

 

food quicker and in larger

 

volumes increases as the

 

burner size increases. It is

 

important to select

 

cookware that is suitable for

 

the amount and type of food

 

being prepared. Select a

 

burner and flame size

 

appropriate for the

Fig. 1

cookware size.

 

The smaller simmer burner (some models) is best suited for simmering delicate sauces, etc. The standard size (9,500 BTU) burners may be used for most surface cooking needs.

The larger quick boil burner or burners (some models) are best used when bringing large quantities of liquid to temperature and when preparing larger quantities of food.

Setting a surface burner

1.Place cooking utensil on top of surface burner grate. Make sure the cooking untensil is centered and stable on the grate.

2.Push the desired surface control knob in and turn counterclockwise out of the OFF position (Fig. 1).

3.Release the knob and rotate to the lite position. Visually check that the gas burner has lit.

4.Push the control knob in and turn counterclockwise to the desired flame size. Use the control knob markings and adjust the flame as needed.

IMPORTANT

In the event of an electrical power outage, the surface burners can be lit manually. To light a surface burner, hold a lit match to the burner head, then slowly turn the surface control knob to lite. After burner lights push in and turn knob to desired setting. Use caution when lighting surface burners manually.

NOTE

DO NOT cook with the surface control knob left in the LITE position. The electronic ignitor will continue to spark if the control knob is left in the LITE position. When setting any surface control knob to the LITE position, all electronic ignitors will spark at the same time. However, only the surface burner you are setting will ignite.

SETTING SURFACE CONTROLS

CAUTION

Do not place flammable items such as plastic salt and pepper shakers, spoon holders or plastic wrappings on the cooktop when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the range cooktop.

Seasoning, using and caring for the griddle

Before first use:

Wash griddle in hot soapy water. Rinse and dry completely.

Apply a thin coat of vegetable oil to the entire surface (front and back of griddle).

Preheat your oven to 350°F. Place the griddle on the upper rack in your oven.

Bake griddle for 1 hour at 350°F, then turn oven OFF and let cool before removing.

The surface may appear to have a tacky feel to it from the seasoning process. If desired, wash the griddle in hot soapy water, rinse well, and dry completely.

Using the griddle:

Remove the center burner grate and carefully replace with the griddle (some models). Preheat the griddle for 5 minutes on medium to medium low setting. Slow preheat ensures even heat distribution during the cooking process. DO NOT preheat the griddle on HI setting. Preheating on HI may warp the griddle and prevent even heat distribution.

After each use:

To prevent rusting, store in a dry place and keep uncovered.

After each use, clean with a stiff brush and hot water only.

Do not clean griddle in the dishwasher.

Dry Immediately and apply a light coating of vegetable oil to griddle before storing.

Home Canning

Be sure to read and observe all the following points when home canning with your appliance. Check with the USDA (United States Department of Agriculture) website and be sure to read all the information they have available as well as follow their recommendations for canning procedures.

Use only quality flat bottom canners when home canning. Use a straight-edge to check canner bottom (see “Cookware material types” in the Before setting surface controls section).

Start with hot tap water to bring water to boil more quickly.

Use the highest heat seating when first bringing the water to a boil. Once boiling is achieved, reduce heat to lowest possible setting to maintain that boil.

11

Image 11
Contents Use&Care Product Record and Registration ContentsDefinitions Important Safety InstructionsImportant Safety Instructions Important Instructions for Using Your Cooktop Conversion to Liquefied Petroleum Gas Grounding InstructionsYour gas range features include Features AT a GlanceBefore Setting Oven Controls Special dark coating on the left and right rack Effortless Oven Rack systemTo assemble the Effortless Oven Rack system Set proper burner flame size Before Setting Surface ControlsUsing proper cookware Correct flame setting Incorrect flame settingSeasoning, using and caring for the griddle Setting Surface ControlsSetting surface controls Setting a surface burnerOven Control Functions Minimum & maximum control settingsFeature Min. temp. /time Max. temp. /time Changing oven temperature display Setting Oven ControlsSetting the clock Setting 12 or 24 hour display modesAdd a minute feature Setting a silent control panelSetting oven lockout Setting the minute timerWhen the set bake time runs out Setting quick preheatSetting bake Setting bake timeSetting Oven Controls Convect roast all models Convect bake all modelsSetting convect convection convert Close the oven door Suggested broil settings table gas ovenBroil To set broil Step PressSetting keep warm Setting pizza featureSetting chicken nuggets feature Setting chicken nuggets feature cont’dOperating the oven light Adjusting the oven temperatureExample increase the oven temperature by 30F Step Press Example decrease the oven temperature by 30F Step PressBake time and delay start pads To Set the Sabbath Feature for use onIf a timed bake or delayed timed bake is needed To Set the Sabbath Feature cont’d Adhere to the following self-clean precautions SELF-CLEANINGSelf-cleaning Veryhot When the self-clean cycle has completedCleaning recommendation table Care & CleaningReplacing the oven light Cleaning the cooktop and surface burnersTo clean the burner head ignition ports To clean the surface burner headsTo replace oven door Removing and replacing the lift-off oven doorTo remove oven door Care & Cleaning section Problem SolutionBefore YOU Call Solutions to common problems Disclaimer of Implied Warranties Limitation of Remedies Major Appliance Warranty