Frigidaire 316901300, CGGF3054KF Before YOU Call Solutions to common problems

Page 30

BEFORE YOU CALL • Solutions to common problems

Problem

Solution

 

 

Soil not completely removed after self- cleaning cycle.

Failure to clean bottom, front top of oven, frame of oven or door area outside oven seal. These areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before the self-cleaning cycle is started. Burned-on residue can be cleaned with a stiff nylon brush and water or a nylon scrubber. Be careful not to damage the oven gasket.

Oven smokes excessively during broiling.

• Incorrect setting. Follow broiling instructions in Setting Oven Controls.

 

• Make sure oven door closed.

 

• Meat too close to upper burner. Reposition the broil rack to provide

 

proper clearance between the meat & the burner. Preheat the oven.

 

• Meat not properly prepared. Remove excess fat from meat. Cut remaining

 

fatty edges to prevent curling, but do not cut into lean.

 

• Broiler pan and insert wrong side up and grease not draining. Always

 

place grid on the broiler pan with ribs up & slots down to allow grease to

 

drip into pan (some models).

 

• Grease has built up on oven surfaces. Regular cleaning is necessary when

 

broiling frequently. Old grease or food spatters cause excessive smoking.

 

 

Flames inside oven or smoking from

• Excessive spillovers in oven. For example this will happen for pie

oven vent.

spillovers or large amounts of grease left on the oven bottom. Wipe up

 

excessive spillovers before starting oven. If flames or excessive smoke

 

are present see “Broiling” in the Setting Oven Controls section.

Oven control panel beeps & displays any F code error (for example F10).

Oven control has detected a fault or error condition. Press CANCEL to clear the display & stop beeping. Try the bake or broil feature again. If the F code error repeats, remove power from appliance, wait 5 minutes and then repower appliance and set clock for the time of day. Try the bake or broil feature again. If the fault recurs, record fault and call for service.

Oven light does not work.

Be sure the light is secure in the socket. Also see “Changing & replacing the oven light” section.

Appliance is not level.

• Be sure floor is level, strong & stable enough to adequately support range.

 

• If floor is sagging or sloping, contact a carpenter to correct the situation.

 

• Poor installation. Place oven rack in center of oven. Place a level on the

 

oven rack. Adjust leveling legs at base of appliance until the rack is level.

 

• Kitchen cabinet alignment may make range appear not level. Be sure

 

cabinets are square & have sufficient room for appliance clearance.

Cannot move appliance easily. Appliance must be accessible for service.

Cabinets not square or are built in too tightly. Contact builder or installer to make appliance accessible.

Carpet interferes with appliance. Provide sufficient space so appliance can be lifted over carpet.

30

Image 30
Contents Use&Care Contents Product Record and RegistrationImportant Safety Instructions DefinitionsImportant Safety Instructions Important Instructions for Using Your Cooktop Grounding Instructions Conversion to Liquefied Petroleum GasFeatures AT a Glance Your gas range features includeBefore Setting Oven Controls Effortless Oven Rack system To assemble the Effortless Oven Rack systemSpecial dark coating on the left and right rack Correct flame setting Incorrect flame setting Before Setting Surface ControlsUsing proper cookware Set proper burner flame sizeSetting a surface burner Setting Surface ControlsSetting surface controls Seasoning, using and caring for the griddleMinimum & maximum control settings Feature Min. temp. /time Max. temp. /timeOven Control Functions Setting 12 or 24 hour display modes Setting Oven ControlsSetting the clock Changing oven temperature displaySetting the minute timer Setting a silent control panelSetting oven lockout Add a minute featureSetting bake time Setting quick preheatSetting bake When the set bake time runs outSetting Oven Controls Convect bake all models Convect roast all modelsSetting convect convection convert To set broil Step Press Suggested broil settings table gas ovenBroil Close the oven doorSetting chicken nuggets feature cont’d Setting pizza featureSetting chicken nuggets feature Setting keep warmExample decrease the oven temperature by 30F Step Press Adjusting the oven temperatureExample increase the oven temperature by 30F Step Press Operating the oven lightTo Set the Sabbath Feature for use on If a timed bake or delayed timed bake is neededBake time and delay start pads To Set the Sabbath Feature cont’d SELF-CLEANING Self-cleaningAdhere to the following self-clean precautions When the self-clean cycle has completed VeryhotCare & Cleaning Cleaning recommendation tableTo clean the surface burner heads Cleaning the cooktop and surface burnersTo clean the burner head ignition ports Replacing the oven lightRemoving and replacing the lift-off oven door To remove oven doorTo replace oven door Problem Solution Care & Cleaning sectionBefore YOU Call Solutions to common problems Major Appliance Warranty Disclaimer of Implied Warranties Limitation of Remedies