Sherwood R-956 manual Universal Remote Control, Digi Link System Remote

ENGLISH

Universal Remote Control

Note: For additional Universal Remote Control programming instructions and manufacturer’s codes, please refer to the operating manual enclosed with this Universal Remote Control.

This remote control has 3 operating modes as follows;

•OSD (On-Screen Display) Mode: Allows you to see information about basic operation of this unit on your TV or monitor and to operate this unit by moving an arow(cursor) that appears on the TV screen.

•Sherwood Mode: Allows you to operate this unit and other Sherwood components like cassettte decks, CD players, etc. via the remote control. (To operate other Sherwood components, please make the Digi Link connections between the components.)

•Non-Sherwood Mode: Allows you to operate other brands of audio and video components that are remote compatible. Notes:

•The setup code for each component must be entered before the remote will operate the component.

•For setup codes (manufacturer’s codes), please refer to the “MANUFACTURER’S CODES” in the operator’s manual that came with the remote control.

•The buttons may have different functions depending upon the chosen component and the operating mode.

•Please be sure to set the remote control to the correct component mode before trying to operate any component.

DIGI LINK SYSTEM REMOTE

•This section explains the basic functions for the Sherwood and the OSD modes. For the non-Sherwood mode, please refer to the operating manual that came with the remote control.

•All Sherwood components bearing the DIGI LINK (II or III) logo can be used with this remote control.

•To control associated Sherwood Digi LInk components, you must first make the DIGI LINK connections between the components.

•With the Sherwood Digi Link III system, pressing a transport control button such as PLAY, on a Sherwood CD player or tape deck will automatically engage that input on the receiver and then PLAY will start.

•The numbered buttons on the remote control have different functions in different modes. For details, please refer to the “FUNCTION TABLE for the NUMBERED BUTTONS” on the following page.

•Each time a button on the remote control is pressed, the buttons will illuminate for approximately 5 seconds.

LED LAMP

	T
SETUP BUTTON	SE UP			PWR	POWER BUTTON
COMPONENT BUTTONS	AUD	CD	DVD	AUX
• To operate the desired component	SAT	TV	VCR	CBL
with this remotecontrol, first select the					NUMERIC(1~0) BUTTONS
corresponding COMPONENT button.	1		2	3
					• For selecting preset stations in tuner mode.
	4		5	6	• For selecting a track or a disc in CD mode, etc.
	7		8	9	• When selecting a disc, select disc No. (1~5)
					within 2 sec. after pressing DISC(marked "P.SCAN") button.
	MUTE		0	CH SEL
			P.SCAN
VOLUME UP/DOWN			SLEEP		CHANNEL LEVEL UP/DOWN
	VOL			CH LEVEL
( / ) BUTTONS			T.TONE		( / ) BUTTONS
		D.TIME	D.ADJ

ENTER BUTTON

ENTER

		OSD
AUTO	STEREO
DSP MODE	6.1CH IN
PHONO	CD	TUNER	TAPE MON
T2 MON	VID SEL	VID 2	VID 3
VID 4	AUX	ROOM 2	SYS DISP

CURSOR CONTROL(, , , ) BUTTONS

•For moving an arrow with the CURSOR CONTROL buttons in the OSD mode.

HOME THEATER MASTER

RNC-30

1 0