Frigidaire Dual Fuel Range Slide-in Models Adjusting Your Oven Temperature, Changing Oven Light

Page 19

Care & Cleaning

Changing Oven Light

Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life.

An interior oven light will turn on automatically when the oven is opened. The oven light may also be turned on and off when the door is closed by using the oven light switch located on the control panel or on the electronic oven control.

The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE

IN PLACE WHEN THE OVEN IS IN USE.

To Replace the Light Bulb:

BE SURE OVEN IS COOL

1.Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3. Replace bulb with a 40 Watt appliance bulb only.

4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.

To Remove the “Hidden Bake” Cover (some models)

1.In order to remove the “hidden bake” cover, pull the back edge with one hand about 1/2" inch and lift up the “hidden bake” cover with both hands. (See picture)

2.When re-installing the “hidden bake” cover, be sure to put it all the way to the back of the oven and lay it down on the 2 shoulder screws. Then push the front edge of the cover in its place below the front bracket.

To have easier access to the "hidden bake" cover, you can remove the oven door by following the instructions on previous page.

IMPORTANT: Always replace the “hidden bake” cover before the next use.

Adjusting Your Oven Temperature

For instructions on how to adjust the oven temperature refer to the electronic oven control guide.

19

Image 19
Contents Before You Call Before SettingWelcome 10-11Register Your Product Welcome & CongratulationsQuestions? Versión en españolFor Your Safety Important Safety InstructionsWhat to do if YOU Smell GAS Important Instructions for Usingyour Cooktop Conversion to Liquefied Petroleum Gas or L.P. Gas Features At a Glance 14K or 12K Before Setting Surface ControlsControl Locations of the Gas Surface Burners Remember do not Allow SPILLS, FoodFlame Size Type of Cooking Setting Surface ControlsSetting Proper Surface Burner Flame Size Operating the Gas Surface ControlsOven Vent Before Setting Oven ControlsArranging Oven Racks Removing and Replacing Oven RacksArranging Warm & Serve Drawer Rack Positions Setting Warm & Serve Drawer Controls some modelsUsing the Warm & Serve Drawer Air Circulation in the OvenFood Item Setting Oven ControlsWarm & Serve Drawer Temperature Selection To Set the Warm & Serve Drawer ControlsOven Baking Cooking InformationsBroiling Self-Cleaning Oven Care & CleaningSelf-Cleaning To Set the Self-Clean CycleEasier into the rack positions Surfaces How to CleanControl Panels Stainless Steel some models Oven door & drawer front panelAllow SPILLS, FOOD, Cleaning Agents or ANY Other Material to Cleaning the Cooktop, Burner Heads, Caps & GratesTo Remove Oven Door Removing and Replacing the Oven DoorHinge Slot Door re- moved from the oven Figure Lock in normal positionTo Remove Warm & Serve Drawer Removing and Replacing Warm & Serve DrawerTo Remove the Hidden Bake Cover some models Adjusting Your Oven TemperaturePlace When the Oven is in USE Changing Oven LightSurface burner flame burns half way around Before you callRange is not level Entire range or oven does not operatePoor baking results Self-cleaning cycle does not workSoil not completely removed after self- cleaning cycle Surface burner flame is orangeExclusions Major Appliance Warranty Information