Frigidaire Dual Fuel Range Slide-in Models Surface burner flame is orange, Poor baking results

Page 21

Before you call

Solutions to Common Problems

Surface burner flame is orange.

Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.

Salt air in coastal areas. A slightly orange flame is unavoidable.

Poor baking results.

Many factors affect baking results. Make sure the proper rack position is used.

 

Center food in the oven and space pans to allow air to circulate. Allow the oven to

 

preheat to the set temperature before placing food in the oven. Try adjusting the

 

recipes’ recommended temperature or baking time. If you feel the oven is too hot or

 

cool, see “Adjusting the Oven Temperature” section in the Electronic Oven Control

 

Guide.

Fan noise during cooking operation.

A cooling fan may automatically turn on and off to cool internal parts. It is normal, and the fan may continue to run even after oven is turned off.

Flames inside oven or smoking from vent.

Excessive spillovers in oven. Set self-clean cycle for a longer cleaning time.

Excessive spillovers in oven. This is normal, especially for pie spillovers or large amounts of grease on the oven bottom. Wipe up excessive spillovers before starting the self-clean cycle. If flames or excessive smoke are present, stop the self-clean cycle and follow the steps under "Stopping or Interrupting the Self-Cleaning Cycle" in the Electronic Oven Control Guide.

Oven smokes excessively during

Meat is too close to the element. Reposition the rack to provide proper clearance

broiling.

between the meat and the oven boil element.

 

 

 

Meat is not properly prepared. Remove excess fat from meat. Remove remaining

 

fatty edges to prevent the meat from curling, but do not cut into the lean of the meat.

 

 

 

Broiler pan used without the Broiler Pan Insert or insert is covered with foil. DO NOT

 

use your Broiler Pan without the Broiler Pan Insert or cover the insert with foil.

 

 

 

Broiler Pan or Broiler Pan Insert needs to be cleaned. Excessive smoking is caused

 

by buildup of grease or food spatters. Clean your Broiler Pan and Insert on a regular

 

basis.

 

 

 

Oven door is closed. Oven door should be open at the broil stop position when

 

broiling.

 

 

Self-cleaning cycle does not work.

Control(s) not set properly. Follow instructions under “Oven Cleaning” in the Electronic Oven Control Guide.

Self-cleaning cycle was interrupted. Stop time must be 2 to 4 hours past the start time. Follow steps under "Stopping or Interrupting the Self-Cleaning Cycle" in the Electronic Oven Control Guide.

Soil not completely removed after self- cleaning cycle.

Set Self-Clean cycle for a longer cleaning time.

Failure to clean bottom front, top of oven or door areas outside oven seal. These areas are not in the Self-Cleaning area, but get hot enough to burn on food residue. Clean these areas before starting the Self-Clean cycle. Burned-on residue may be cleaned with a stiff nylon brush and water or nylon scrubber. Be careful not to damage the oven gasket.

Excessive smoking from oven vent.

Excessive spillovers in oven, especially for pie spillovers or large amounts of grease on the oven bottom. Wipe up excessive spillovers before starting the Self-Clean cycle. If flames or excessive smoke are present, stop the Self-Clean cycle and follow the steps under "Stopping or Interrupting the Self-Cleaning Cycle" in the Electronic Oven Control Guide.

21

Image 21
Contents Welcome Before Setting10-11 Before You CallQuestions? Welcome & CongratulationsVersión en español Register Your ProductImportant Safety Instructions For Your SafetyWhat to do if YOU Smell GAS Important Instructions for Usingyour Cooktop Conversion to Liquefied Petroleum Gas or L.P. Gas Features At a Glance Control Locations of the Gas Surface Burners Before Setting Surface ControlsRemember do not Allow SPILLS, Food 14K or 12KSetting Proper Surface Burner Flame Size Setting Surface ControlsOperating the Gas Surface Controls Flame Size Type of CookingArranging Oven Racks Before Setting Oven ControlsRemoving and Replacing Oven Racks Oven VentUsing the Warm & Serve Drawer Setting Warm & Serve Drawer Controls some modelsAir Circulation in the Oven Arranging Warm & Serve Drawer Rack PositionsWarm & Serve Drawer Temperature Selection Setting Oven ControlsTo Set the Warm & Serve Drawer Controls Food ItemOven Baking Cooking InformationsBroiling Self-Cleaning Care & CleaningTo Set the Self-Clean Cycle Self-Cleaning OvenControl Panels Surfaces How to CleanStainless Steel some models Oven door & drawer front panel Easier into the rack positionsAllow SPILLS, FOOD, Cleaning Agents or ANY Other Material to Cleaning the Cooktop, Burner Heads, Caps & GratesHinge Slot Door re- moved from the oven Figure Removing and Replacing the Oven DoorLock in normal position To Remove Oven DoorTo Remove Warm & Serve Drawer Removing and Replacing Warm & Serve DrawerPlace When the Oven is in USE Adjusting Your Oven TemperatureChanging Oven Light To Remove the Hidden Bake Cover some modelsRange is not level Before you callEntire range or oven does not operate Surface burner flame burns half way aroundSoil not completely removed after self- cleaning cycle Self-cleaning cycle does not workSurface burner flame is orange Poor baking resultsExclusions Major Appliance Warranty Information