Frigidaire pmn To Remove and Replace Oven Door, To Remove and Replace Warmer Drawer if equipped

Page 19

General Cleaning

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove and Replace Oven Door

To Remove Oven Door:

1.Open the door.

2.Remove screws located on the inside of the oven door near the hinges A (one on each side.)

3.Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up and off the hinges.

4.To clean oven door, follow the instructions provided in the cleaning chart under General Cleaning

To Replace Oven Door:

1.Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges open by hand. The hinges may snap back against the oven frame and could pinch fingers.

2.Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the door.

 

3.

Hinge arms must go into the range slots evenly. The hinge arms should be

 

 

inserted into the bottom corners of the door as far as they can go.

 

4.

If the door is not in line with the oven frame, remove it and repeat the above

 

 

steps.

 

To Remove and Replace Warmer Drawer (if equipped)

 

To Remove Warmer Drawer:

 

1.

Turn power off before removing the warmer drawer.

 

2.

Open the drawer to the fully opened position.

 

3.

On the right glide you will find a shield attached with a hex-head screw (see

 

 

figure 1). Using a 1/4” socket and ratchet remove the shield.

 

4.

Locate glide lever on each side of drawer, pull up on the left glide lever and

 

 

push down on the right glide lever.

 

5.

Pull the drawer away from the range.

 

To Replace Warmer Drawer:

 

1.

Replace shield on the right glide of the drawer body.

 

2.

Pull the bearing glides to the front of the chassis glide (see figure 2).

Figure 1

3.

Align the glide on each side of the drawer with the glide slots on the range.

4.

Push the drawer into the range until levers “click” (approximately 2”). Pull

 

 

 

the drawer open again to seat bearing glides into position. If you do not

 

 

hear the levers “click” or the bearing glides do not feel seated remove

 

 

the drawer and repeat steps 2-4.This will minimize possible damage to

 

 

the bearing glides.

 

 

Electrical Shock Hazard can occur and result in

 

 

serious injury or death. Disconnect appliance from electric

 

 

power before cleaning and servicing the warmer drawer.

Figure 2

 

 

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Electric Range Record Your Model and Serial Numbers Product RegistrationRegister Your Product Versión en españolImportant Safety Instructions Important Instructions for Using Your Cook TOP Radiant Surface Units Indicator LightsSurface Cooking for Models with a Ceramic- Glass Cook Top Ceramic-Glass CooktopTo Operate Dual Radiant Surface Unit If equipped Setting Surface Controls for Models with Radiant ElementsSetting Type of Cooking To Operate Radiant Surface UnitTo Operate the Warm Zone Setting Warm ZoneSetting Warmer Drawer Oven Vent Location Before Setting Oven ControlsArranging Oven Racks Stop Time PAD- Used to set Start Indicator LIGHT-FlashesOven Control Styles 1 or 2 Control Pad Functions Control StyleTo Set the Clock Style Setting the Clock Minute TimerTo Set the Minute Timer Clock Style Oven Control StyleTo Set the Controls for Normal Baking Oven Control Style 1 or 2 BakeTo Begin Baking Immediately with an Automatic Shut-Off Oven Control Style 2 Automatic TimerFor a Delayed Start Time and Automatic Shut-Off When the Set Bake Time Runs OutRack Position From Top Food Oven Control Styles 1 or 2 BroilClock Style Clock Style To Broil Control Style 1 orSelf-Cleaning Oven Oven Control Styles 1 or 2 Self Cleaning OvenAdhere to the following cleaning precautions When the Self-Clean Cycle is Completed Control Style To Start the Self-Clean Cycle Control StyleCleaning Various Parts of Your Range General CleaningSurfaces How to Clean For heavy, burned-on soil Ceramic-Glass Cooktop CleaningDaily Cleaning For normal soilTo Remove and Replace Warmer Drawer if equipped To Remove and Replace Oven DoorIf equipped To Change the Oven Light some Self Cleaning ModelsChanging Cooktop and/or Oven Lights To Change the Cooktop Light some modelsOven Control Style 1 or 2 Customizing Your Oven Performance To Adjust Oven Temperature Control StyleControl Style Avoid Service Checklist Flames inside oven or smoking from vent Self-cleaning cycle does not workCleaning cycle Poor baking resultsRange Warranty
Top Page Image Contents