Frigidaire pmn Changing Cooktop and/or Oven Lights, To Change the Cooktop Light some models

Page 20

Changing Cooktop and/or Oven Lights

(if equipped)

Be sure the range is unplugged and all parts are COOL before replacing the surface or oven lights. Wear a leather-faced glove for protection against possible broken glass.

To Change the Cooktop Light (some models)

1.Turn power off at the main source or unplug the range.

2.Remove Phillips® Head screws (2) that secure the light cover and then lift the light cover off.

3.Remove bulb by rolling back and up. Install the new bulb by sliding down and rolling forward into place.

4.Re-install light cover and secure with Phillips® Head screws (2).

To Change the Oven Light (some Self Cleaning Models)

On some models, the oven light automatically turns on when the door is opened. Some models have a switch located on the control panel to turn on the light. The oven light is located at the rear of the oven and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.

To replace the oven light:

1.Turn electrical power off at the main source or unplug the range.

2.Press wire holder to one side to release the glass shield.

3.Replace bulb with a new 40 watt appliance bulb.

4.Replace glass shield over bulb and snap wire holder into place.

5.Turn power back on again at the main source (or plug the range back in).

6.The clock(if equipped) will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Owner's Guide.

20

Image 20

Contents Electric Range Product Registration Register Your ProductVersión en español Record Your Model and Serial NumbersImportant Safety Instructions Important Instructions for Using Your Cook TOP Indicator Lights Surface Cooking for Models with a Ceramic- Glass Cook TopCeramic-Glass Cooktop Radiant Surface UnitsSetting Surface Controls for Models with Radiant Elements Setting Type of CookingTo Operate Radiant Surface Unit To Operate Dual Radiant Surface Unit If equippedSetting Warm Zone To Operate the Warm ZoneSetting Warmer Drawer Arranging Oven Racks Before Setting Oven ControlsOven Vent Location Start Indicator LIGHT-Flashes Oven Control Styles 1 or 2 Control Pad FunctionsControl Style Stop Time PAD- Used to setSetting the Clock Minute Timer To Set the Minute Timer Clock StyleOven Control Style To Set the Clock StyleOven Control Style 1 or 2 Bake To Set the Controls for Normal BakingOven Control Style 2 Automatic Timer For a Delayed Start Time and Automatic Shut-OffWhen the Set Bake Time Runs Out To Begin Baking Immediately with an Automatic Shut-OffOven Control Styles 1 or 2 Broil Clock StyleClock Style To Broil Control Style 1 or Rack Position From Top FoodAdhere to the following cleaning precautions Oven Control Styles 1 or 2 Self Cleaning OvenSelf-Cleaning Oven To Start the Self-Clean Cycle Control Style When the Self-Clean Cycle is Completed Control StyleSurfaces How to Clean General CleaningCleaning Various Parts of Your Range Ceramic-Glass Cooktop Cleaning Daily CleaningFor normal soil For heavy, burned-on soilTo Remove and Replace Oven Door To Remove and Replace Warmer Drawer if equippedTo Change the Oven Light some Self Cleaning Models Changing Cooktop and/or Oven LightsTo Change the Cooktop Light some models If equippedControl Style To Adjust Oven Temperature Control StyleOven Control Style 1 or 2 Customizing Your Oven Performance Avoid Service Checklist Self-cleaning cycle does not work Cleaning cyclePoor baking results Flames inside oven or smoking from ventRange Warranty