Sherwood RD-6108 manual Adjusting the speaker settings, Checking the speaker setting

ENGLISH

4		At the desired parameter,	ADJUST	5		Repeat the above steps 3 and 4 to adjust
		adjust it as desired.				other parameters.
				Note:
	If the parameter display disappears, start from the			In the Dolby Pro Logic II Customer mode, you cannot set both of
	step 3 again.			the 7 kHz Low Pass Filter and Shelf Filter to ON simultaneously.
				If so, the filter set previously is automatically changed to OFF.
				7		Select the desired speaker
	Adjusting the speaker settings						ADJUST
						setting.
	Adjust the settings of front, center ,rear speakers and
	subwoofer connected.
	If the speaker setting is adjusted to “S”, the low range
	bass sound of the channel(s) is redirected to the			Each time this button is pressed, one of 11 different
	subwoofer or the front channels and if the speaker
				speaker settings is selected and displayed for 8
	setting is adjusted to “N”, the sound of the channel(s)
				seconds as follows;
	is redirected to other channels.
				FL CS RS, FL CL RS, FL CL RL,
6		Press the SPEAKER	SPEAKER	FL CL RN, FL CS RL, FL CN RL,
		MODE button for more	MODE	FL CS RN, FL CN RS, FS CS RS,
		than 2 seconds to enter the		FS CS RN and FS CN RS
				In the displays, F stands for Front, C for Center, R
		front-center-rear speaker
		mode.		for Rear, L for Large, S for Small and N for None.
	The front-center-rear speaker setting is displayed.			When judging whether a speaker is Large or Small,
				please note that a standard large speaker can fully
	When the SPEAKER button is set to off or the 6 CH			reproduce sounds below 80 Hz.
	DIRECT is selected as an input source, the speaker			The following speaker settings cannot be selected.
	mode function cannot be available.			Front :Small, Center : Large and Rear : Large(FS-
	When it is in the stereo or Dolby Virtual mode, only			CL-RL) or Center : None and Rear : None(CN-RN)
	the subwoofer setting can be adjusted.			setting.
8		Memorize the desired	MEMO/ENTER	9		Select the desired	ADJUST
		speaker setting				subwoofer setting.
		while it is displayed.
				Each time this button is pressed, the subwoofer setting
	The desired speaker setting is memorized and then			changes and is displayed for 8 seconds as follows;
	it enters the subwoofer mode.
					SUB W(oofer) - Y(es): When using a subwoofer.
	If the speaker setting display disappears, start from
	the above step 6 again.				SUB W(oofer) - N(o) : When not using a subwoofer.
				In case that the front speaker is set to “S”, the
				subwoofer is automatically set to “Y”.
		Memorize the subwoofer
10			MEMO/ENTER	Checking the speaker setting
		setting while it is
						SPEAKER
		displayed.
						MODE

If the subwoofer setting display disappears, start	Each time this button is pressed briefly, the front-
from the above step 6 again.	center-rear speaker or subwoofer setting is displayed.

16