Sherwood RD-6108 manual Adjusting each channel level with, Test tone

Adjusting each channel level							Adjust the level of the selected channel
						12 as desired.
Select the desired channel.
11			1	2	3		ADJUST			7	08	9
										1	2	3
										4	5	6
CHANNEL			4	5	6				CH. LEVEL
			7	8	9
SELECTOR		CH. SEL		0
							or
	or
						The LFE level can be adjusted within the range of
Each time this button is pressed, the corresponding						-10~0 dB and other channel levels within the range
channel is selected and displayed for 3 seconds as						of -15~+15 dB.
follows;						In general, we recommend the LFE level to be
Front Left Center Front Right Rear Right						adjusted to 0 dB. (However, the recommend LFE
(Dolby Digital or DTS L(FE)		)SubWoofer			Rear Left	level for some early DTS software is -10 dB.) If the
( ): Adjustable only when the digital signals from Dolby Digital or						recommended levels seems too high, lower the
DTS program source that includes LFE signal are input in the						setting as necessary.
available surround mode.						If the channel display disappears, start from the
When it is in the stereo or Dolby Virtual mode, or
						above step 11 again.
the speaker setting is “N”, center, rear or subwoofer
channel will not be selected.							Repeat the above steps 11 and 12 to
						13 adjust other channel levels.
Adjusting each channel level with						15	At each channel, adjust the level as desired
test tone							until the sound level of each speaker is
Only when it is in available surround modes except							heard to be equally loud.
the Dolby Virtual and stereo modes, the volume
level of each channel can be adjusted easily with the									7	8	9
									1	2	3
									4	5	6
test tone function.						ADJUST		CH. LEVEL		0
Note: When the 6 CH DIRECT is selected as an input							or
source, the test tone function does not work.
Enter the test tone mode.
14	41	52	63			You can select the desired channel and adjust its
T.TONE		0	9			level with repeating the steps 11 and 12 in
	7	8
						“Adjusting each channel level” procedure.
						16	Cancel the test tone function.
The test tone will be heard from the speaker of each
channel for 2 seconds as follows;
Front Left	Center		Front Right				1	2	3
							7	8	9
							4	5	6
SUBwoofer	Rear Left		Rear Right				T.TONE	0

When the speaker setting is “N”, the test tone of the corresponding channel is not available.

When the selected decoding mode is not matched to the input signal format, the test tone function cannot work.

ENGLISH

17