Sherwood RD-6500 manual When canceling the surround mode for stereo operation

ENGLISH

When canceling the surround mode for stereo operation.

STEREO

• Then the stereo mode is selected.

• To cancel the stereo mode, select the desired surround mode with using the DSP MODE button.

Adjusting the Dolby Pro Logic II parameters

•When selecting the Dolby Pro Logic II Music and Custom modes, you can adjust the various surround parameters for optimum surround effect.

3	While scrolling “PL II MUSIC”(for Dolby Pro Logic II Music mode) or “PL II CUSTOM”(for Dolby
	Pro Logic II Custom mode), press the MEMORY/ENTER button to select the desired parameter.
	MEMO/ENTER

• Each time this button is pressed, the parameter changes and is displayed for 5 seconds as follows:

Panorama mode(“PANO”) : This mode extends the front stereo image to include the surround speakers for an exciting “wraparound”effect with side wall imaging. Select “OFF” or “ON”.

Center width control(“C-WID”) : This control adjusts the center image so it may be heard only from the center speaker, only from the left/right speakers as a phantom image, or from all three front speakers to varying degrees. The control can be set in 8 steps from 0 to 7.

Dimension control(“DIMEN”) : This control gradually adjusts the soundfield either towards the front or towards the rear. The control can be set in 7 steps from - 4 to +2.

7 kHz Low Pass Filter(“LPF”) : Select “OFF” or “ON” to turn off or on the pass filter on the surround channels.

Shelf Filter(“SH - F”) : Select “OFF” or “ON” to turn off or on the shelf filter on the surround channels.

Right Surround Channel Polarity Inversion(“PO - I”) : Select “OFF” or “ON” to turn off or on the polarity inversion. Automatic Balancing(“BAL”) : Select “ OFF” or “ON” to turn off or on the automatic balancing

•If the Dolby Pro Logic II Music or Custom display disappears, you cannot select the parameter. In this case, select the desired surround mode again by pressing the DSP MODE button.

•In the Dolby Pro Logic II Music mode, you cannot select the 7 kHz Low Pass Filter, Shelf Filter, Right Surround Channel Polarity Inversion and Automatic Balancing.

•For your reference, the initial settings for parameters are as follows:

“PANO” : “OFF”, “C-WID” : “0”, “DIMEN” : “0”, “LPF” : “OFF”, “SH-F” : “OFF”, “PO-I” : “ON”, “BAL” : “OFF”.

At the desired parameter, adjust it as desired.

4 ADJUST

5

Repeat the above steps 3 and 4 to adjust other parameters.

•If the parameter display disappears, start from the step 3 again.

Note:

•In the Dolby Pro Logic II Customer mode, you cannot set both of the 7 kHz Low Pass Filter and Shelf Filter to ON simultaneously.

If so, the filter set previously is automatically changed to OFF.

16