Sherwood RD-6500 manual Adjusting the speaker settings, Checking the speaker setting

	Adjusting the speaker settings		Select the desired speaker setting.
• Adjust the settings of front, center ,rear speakers and		7	ADJUST
	subwoofer connected.

•If the speaker setting is adjusted to “S”, the low range bass sound of the channel(s) is redirected to the subwoofer or the front channels and if the speaker setting is adjusted to “N”, the sound of the channel(s)

is redirected to other channels.		• Each time this button is pressed, one of 11 different
	Press the SPEAKER MODE button for	speaker settings is selected and displayed for 8
6		seconds as follows;
	more than 2 seconds to enter the front-
		FL-CS-RS, FL-CL-RS, FL-CL-RL,
	center-rear speaker mode.
		FL-CL-RN, FL-CS-RL, FL-CN-RL,
	SPEAKER
	MODE	FL-CS-RN, FL-CN-RS, FS-CS-RS,
		FS-CS-RN and FS-CN-RS
		• In the displays, F stands for Front, C for Center, R
		for Rear, L for Large, S for Small and N for None.
		• When judging whether a speaker is Large or Small,
• The front-center-rear speaker setting is displayed.		please note that a standard large speaker can fully
		reproduce sounds below 80 Hz.
• When the SPEAKER button is set to off or the 6 CH
		• The following speaker settings cannot be selected.
DIRECT is selected as an input source, the speaker
		Front :Small, Center : Large and Rear : Large(FS-
mode function cannot be available.
		CL-RL) or Center : None and Rear : None(CN-RN)
• When it is in the stereo, only the subwoofer setting
		setting.
can be adjusted.
8	Memorize the desired speaker setting	9		Select the desired subwoofer setting.
	while it is displayed.
				ADJUST
	MEMO/ENTER
		• Each time this button is pressed, the subwoofer setting
		changes and is displayed for 8 seconds as follows;
• The desired speaker setting is memorized and then it			SUB W(oofer) - Y(es): When using a subwoofer.
enters the subwoofer mode.			SUB W(oofer) - N(o) : When not using a subwoofer.
• If the speaker setting display disappears, start from
the above step 6 again.
		• In case that the front speaker is set to “S”, the
		subwoofer is automatically set to “Y”.
10	Memorize the subwoofer setting while it
		Checking the speaker setting
	is displayed.
	MEMO/ENTER			SPEAKER
				MODE

• If the subwoofer setting display disappears, start	• Each time this button is pressed briefly, the front-
from the above step 6 again.	center-rear speaker or subwoofer setting is displayed.

ENGLISH

17