Sherwood RD-6500 manual Adjusting each channel level with test

ENGLISH

Adjusting each channel level								Adjust the level of the selected channel
								12 as desired.
Select the desired channel.
11								ADJUST			7	08	9
											1	2	3
											4	5	6
										CH. LEVEL
					1	2	3
CHANNEL					4	5	6	or
					7	8	9
SELECTOR		CH. SEL				0
	or
								• The LFE level can be adjusted within the range of
• Each time this button is pressed, the corresponding								-10~0 dB and other channel levels within the range of
								-15~+15 dB.
channel is selected and displayed for 3 seconds as
								• In general, we recommend the LFE level to be
follows;
								adjusted to 0 dB. If the recommended levels seems
Front Left Center		Front Right			Rear Right
								too high, lower the setting as necessary.
(Dolby Digital L(FE)		)SubWoofer			Rear Left			• If the channel display disappears, start from the above
( ): Adjustable only when the digital signals from Dolby Digital program								step 11 again.
source that includes LFE signal are input in the available surround
mode.
• When it is in the stereo, or the speaker setting is “N”,								Repeat the above steps 11 and 12 to
center, rear or subwoofer channel will not be selected.
								13 adjust other channel levels.
Adjusting each channel level with test								At each channel, adjust the level as desired
								until the sound level of each speaker is
tone
								15 heard to be equally loud.
• Only when it is in available surround modes except
stereo mode, the volume level of each channel can
be adjusted easily with the test tone function.										1	2	3
										4	5	6
Note: When the 6 CH DIRECT is selected as an								ADJUST		7	8	9
									CH. LEVEL		0
input source, the test tone function does not								or
work.
Enter the test tone mode.
14		41	52	63				• You can select the desired channel and adjust its level
	T.TONE	7	8	9				with repeating the steps 11 and 12 in “Adjusting each
			0
								channel level” procedure.
								Cancel the test tone function.
• The test tone will be heard from the speaker of each								16
channel for 2 seconds as follows;
Front Left	Center		Front Right					1	2	3
								7	8	9
								4	5	6
SUBwoofer	Rear Left				Rear Right			T.TONE	0

• When the speaker setting is “N”, the test tone of the corresponding channel is not available.

•When the selected decoding mode is not matched to the input signal format, the test tone function cannot work.

18