DeLonghi DL 48 P6E manual Position

Page 11

LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE SAFETY DEVICE (Dual Burners)

In order to light the burner, you must:

1 – Push and turn the knob in an anti-clockwise direction up to the position (maximum rate of inner crown); push in and hold the knob until the flame has been lit.

The sparks produced by the lighter situated inside the relative burner will light the flame.

In the event that the local gas supply conditions makes it difficult to light the burn-

er in

position, try again with the knob in

position.

If there is no mains electrical supply connection, bring a lighted match close to the burner.

2 – Wait for about ten seconds after the gas burner has been lit before letting go the knob (safety device activation delay).

2 – Adjust the gas valve to the desired position.

If the burner flame should go out for some reason, the safety valve will automatically stop the gas flow.

To re-light the burner, return the knob to the closed position ( ), wait for at least 1 minute and then repeat the lighting procedure.

N.B. When the range is not being used, set the gas knobs to their positions and also close the gas shut-off valve placed on the main gas supply line.

CAUTION!

The range becomes very hot during operation. Keep children well out of reach.

11

Image 11
Contents Dual Fuel Self Cleaning Range ALL Ranges can TIP Dear Customer Electrical Grounding Instructions Replacement PartsImportant Precautions and Recommendations Cooking HOB FeaturesControls Description GAS Burners Rapid and triple ring How to use the top burnersPage GAS Burners Dual Position Correct USE of Dual Burners .6a 2.6b Choice of Burner figTo USE the Warming Drawer How to use the warmer drawerGeneral Features Using the Warming Drawer for the First TimeMoisture Selector fig Temperature SelectorUsing the Ovens for the First Time How to use the self cleaning ovensOven Light this is not a cooking function Selecting the Functions figTraditional Convection Cooking Important Notes Turn the oven selector knob to a cooking function i.e. Bake Selecting F/C on the DisplayHOW to Start the Self Cleaning Cycle Steady door Problems on Starting and During the Self Cleaning CycleIf the oven cavity temperature is higher than 570 F 300 C HOW to Stop the Self Cleaning CycleDuring cooking or the self cleaning cycle Abnormal Situations AND/OR Operation ProblemsCooking Different Dishes AT the Same Time Cooking Advice SterilizationRegeneration RoastingStep Broiling Audible Signal How to use the electronic programmerSetting the Time SEMI-AUTOMATIC Cooking TimerAutomatic Cooking Examples of Programming Automatic Cooking Cancelling a SET ProgrammeCleaning and maintenance Correct Position of Triple Ring Burners Correct Replacement of the Rapid BurnersGAS Valves Oven Shelf Installation and RemovalCorrect Position of Dual Burners Fitting the Warmer Drawer fig Removing the Warmer Drawer figRemoving the Oven Door Replacing the Oven Light figDO’S and do NOT’S For Your SafetyCod ß4