DeLonghi DL 48 P6E manual Automatic Cooking

Page 28

I

I

I

I

I

I

I

 

I

I

II

2

5

6

I

I

I

I

I

I

I

 

I

I

II

3

5

6

I

I

I

 

I

 

I

 

I

I

 

I I

I

I

I

I

AUTOMATIC COOKING

Start cooking at the programmed time and switch the oven off automatically after the programmed cooking time.

Setting

1.Set the cooking function by turning the oven selector to the function required.

2.The cooking temperature appears on the display. To change it proceed as described in the Setting the cooking chapter.

3.Press pushbutton 2. AUTO starts to flash and 0.00 appears.

4.Press pushbuttons 5 or 6 to set the cooking time (cooking time in hours and minutes: set it to ten minutes less than the time required because the stored heat will complete the cooking).

5.On the display AUTO becomes steady and the cooking programme starts.

6.Press pushbutton 3 (AUTO starts to flash).

7.Press pushbuttons 5 or 6 to set the time when the cooking should finish.

The values set must be correct; e.g. if it is 08:00 a cooking time of 3 hours, ending at 10:00, cannot be set. In this case the programmer automatically sets the end of cook- ing time for 11:00.

8.On the display AUTO becomes steady and the time appears again. The cooking symbol goes out.

I

I

I

I

I

I

I

I

I

 

II

28

Starting cooking

9.The pan symbol lights up. The oven switches on and the cooking cycle set starts.

During cooking

10.During the cooking cycle, the display shows the oven temperature measured by the probe or pre-setted temperature.

Press key 2 to display the length of cooking set. Press key 3 to display when the cooking will finish.

The cooking time, end of cooking time and cooking temperature can be varied at any time, as described above.

At the end of cooking

11.End appears on the display, AUTO flashes and the audible signal sounds. The cooking cycle has finished and the oven is OFF.

13.Press any pushbutton to stop the audible signal.

14.OFF appears (oven OFF).

15.Turn the function selector to OFF (oven OFF).

16.The programmer display shows the time.

Note: At the end of the programme always turn the function selector knob to OFF (oven OFF).

IMPORTANT: During AUTOMATIC COOKING PROGRAM the oven light is always on, also before starting (heating elements on or cycling) of the programmed cooking.

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Dual Fuel Self Cleaning Range ALL Ranges can TIP Dear Customer Replacement Parts Electrical Grounding InstructionsImportant Precautions and Recommendations Features Cooking HOBControls Description How to use the top burners GAS Burners Rapid and triple ringPage GAS Burners Dual Position Choice of Burner fig Correct USE of Dual Burners .6a 2.6bHow to use the warmer drawer General FeaturesUsing the Warming Drawer for the First Time To USE the Warming DrawerTemperature Selector Moisture Selector figHow to use the self cleaning ovens Using the Ovens for the First TimeSelecting the Functions fig Oven Light this is not a cooking functionTraditional Convection Cooking Important Notes Selecting F/C on the Display Turn the oven selector knob to a cooking function i.e. BakeHOW to Start the Self Cleaning Cycle Problems on Starting and During the Self Cleaning Cycle Steady doorHOW to Stop the Self Cleaning Cycle If the oven cavity temperature is higher than 570 F 300 CAbnormal Situations AND/OR Operation Problems During cooking or the self cleaning cycleCooking Advice Sterilization RegenerationRoasting Cooking Different Dishes AT the Same TimeStep Broiling Setting the Time How to use the electronic programmerAudible Signal Timer SEMI-AUTOMATIC CookingAutomatic Cooking Cancelling a SET Programme Examples of Programming Automatic CookingCleaning and maintenance Correct Replacement of the Rapid Burners Correct Position of Triple Ring BurnersCorrect Position of Dual Burners Oven Shelf Installation and RemovalGAS Valves Removing the Warmer Drawer fig Fitting the Warmer Drawer figReplacing the Oven Light fig Removing the Oven DoorFor Your Safety DO’S and do NOT’SCod ß4
Top Page Image Contents