DeLonghi DL 48 P6E manual Timer, SEMI-AUTOMATIC Cooking

Page 27

TIMER

I

I

I

The timer function is only used to count the time and does not influence oven operation or any programmes which are in progress or set.

I

I

I

I

I

1

5

6

1.Press pushbutton 1. The bell symbol will start to flash.

2.Press keys 5 or 6 to set the time required.

3.The countdown starts immediately. The bell symbol stops flashing and the time appears again.

4.To see the countdown press pushbutton 1. The time will be indicated in hours and minutes; the seconds are only indicated for the last minute.

5.At the end of the countdown an audible signal sounds and the bell symbol on the dis- play flashes.

Press any pushbutton to stop the audible signal.

IMPORTANT WARNING: This function is only an electronic alarm and does not switch OFF the oven. Remember to turn OFF manually the selector knob at the end of the countdown.

SEMI-AUTOMATIC COOKING

Start immediate cooking and switch the oven off automatically after the programmed cooking time.

Setting

1.Set the cooking function by turning the oven selector to the function required.

2.The cooking temperature appears on the display. To change it proceed as described in the Setting the cooking chapter

3.Press pushbutton 2. AUTO starts to flash and 0.00 appears.

4.Press pushbuttons 5 or 6 to set the cooking time (cooking time in hours and min- utes: set it to ten minutes less than the time required because the stored heat will complete the cooking).

5.On the display AUTO becomes steady and the cooking programme starts.

During cooking

6.During the cooking cycle, the display shows the oven temperature measured by the probe or pre-setted temperature.

Press key 2 to display the time remaining until the end of cooking.

The cooking time and temperature can be varied at any time, as described above.

At the end of cooking

7.End appears on the display, AUTO flashes and the audible signal sounds. The cooking cycle has finished and the oven is OFF.

8.Press any programmer pushbutton to stop the audible signal.

9.OFF appears (oven OFF).

10.Turn the function selector to OFF (oven OFF).

11.The programmer display shows the time.

Note: At the end of the programme always turn the function selector knob to OFF (oven OFF).

I

I

I

 

I

I

 

I

I

 

I

I

 

 

I

I

 

I

I

 

 

I

I

I

I

I

I

I

I

I

II

2

5

6

I

I

I

I

I

I

I

I

I

 

II

27

Image 27
Contents Dual Fuel Self Cleaning Range ALL Ranges can TIP Dear Customer Electrical Grounding Instructions Replacement PartsImportant Precautions and Recommendations Cooking HOB FeaturesControls Description GAS Burners Rapid and triple ring How to use the top burnersPage GAS Burners Dual Position Correct USE of Dual Burners .6a 2.6b Choice of Burner figTo USE the Warming Drawer How to use the warmer drawerGeneral Features Using the Warming Drawer for the First TimeMoisture Selector fig Temperature SelectorUsing the Ovens for the First Time How to use the self cleaning ovensOven Light this is not a cooking function Selecting the Functions figTraditional Convection Cooking Important Notes Turn the oven selector knob to a cooking function i.e. Bake Selecting F/C on the DisplayHOW to Start the Self Cleaning Cycle Steady door Problems on Starting and During the Self Cleaning CycleIf the oven cavity temperature is higher than 570 F 300 C HOW to Stop the Self Cleaning CycleDuring cooking or the self cleaning cycle Abnormal Situations AND/OR Operation ProblemsCooking Different Dishes AT the Same Time Cooking Advice SterilizationRegeneration RoastingStep Broiling How to use the electronic programmer Setting the TimeAudible Signal SEMI-AUTOMATIC Cooking TimerAutomatic Cooking Examples of Programming Automatic Cooking Cancelling a SET ProgrammeCleaning and maintenance Correct Position of Triple Ring Burners Correct Replacement of the Rapid BurnersOven Shelf Installation and Removal Correct Position of Dual BurnersGAS Valves Fitting the Warmer Drawer fig Removing the Warmer Drawer figRemoving the Oven Door Replacing the Oven Light figDO’S and do NOT’S For Your SafetyCod ß4