DeLonghi DL 48 P6E manual Selecting F/C on the Display

SELECTING °F/°C ON THE DISPLAY

1.Turn the oven selector knob to a cooking function (i.e. BAKE).

2.Press key 5 on the programmer to reduce the temperature until you reach the min- imum value (120 °F/50 °C).

3.With °F/°C flashing on the display press key 5 again (if °F/°C is not flashing press key 4 before pressing key 5) until OFF appears on the display.

4.Keep key 4 pressed for about 3/5 seconds until the display changes from °C to °F or vice versa. During selection °C or °F is flashing.

5.When OFF apears again on the display turn the selector knob to OFF position; the selection to °C or °F has been completed.

SETTING THE COOKING (ONLY FOR THE COOKING FUNCTIONS)

The temperature set is shown on the electronic programmer display and can be varied, with 5 °F (5 °C) intervals, by means of the programmer keys.

During the cooking the oven temperature (°F or °C) is measured by a sensor inside the cavity and is shown on the programmer display until setted temperature is reached. If setted temperature is less than inside oven temperature, the display shows the setted temperature.

1.SELECTING THE COOKING FUNCTION

Turn the selector knob to the cooking function required

The pre-set temperature appears on the programmer display. °F or °C flashes on the display for 3 seconds. The heating elements start cooking immediately.

2.SETTING THE COOKING TEMPERATURE

The temperature can be changed when °F or °C is flashing on the display

2a. If °F or °C is not flashing press key 4 of the programmer.

2b. Press key 6 to increase the temperature or key 5 to reduce it.

The maximum temperature which can be set is 480 °F (250 °C) while the minimum temperature is 120 °F (50 °C).

Note: When °F or °C becomes steady the value shown on the display indicates the oven cavity temperature until setted temperature is reached. If setted temperature is less than inside oven temperature, the display shows the setted temperature.

Caution: If a temperature below the minimum value (120 °F or 50 °C) is set the system switches off automatically and OFF appears.

In this case repeat the procedure from point 2.

3.SWITCHING OFF

Turn the selector knob to position OFF (oven OFF). The programmer display shows the time.

➀

I	I	I
		I
I		I
I		I
I
		I
I
	I	I

➁ 5

➂ 5

➃	4
➄
Left oven	Right oven
programmer	programmer

Left oven	Right oven
function selector knob	function selector knob

➀

	I	I	I	I
	I			I
	I			I
	I
				I
	I	I	I
➁	4	5		6

2a 2b

19