GE JBP25GR Installation Instructions, Aluminum Wiring Connect length of copper building wire to

Page 28

INSTALLATION INSTRUCTIONS

STEP 4 (continued)

2.Aluminum Wiring

A. Connect length of copper building wire to

range terminal block.

B. Splice copper wires to aluminum wiring using special connectors designed and U.L. approved for joining copper to aluminum, and follow the connector manufacturer’s recommended procedure closely.

NOTE: Wire used, location and enclosure of splices, etc., must conform to good wiring practice and local codes.

STEP 5

4+IRE SYSTEM

SPECIAL GROUNDING INSTRUCTIONS

WARNING:

Frame grounded to neutral of appliance through a link. If used in a MOBILE HOME or if LOCAL CODES do not permit grounding through the neutral:

1.Disconnect the link from neutral.

2.Use grounding terminal or lead to ground unit in accordance with local codes.

3.Connect neutral terminal or lead to branch circuit in usual manner.

(If the appliance is to be connected by means of a cord set, use 4-conductor cord for this purpose.) ,, ,,

:P8::CT”R’ LJ lul J“

c,

GROUND

4TH GROUNDING LEAD ~ F LUG

STEP 6

ANTI-TIP BRACKET INSTALLATION

AN ANTI-TIP bracket is supplied with instructions for installation in a variety of locations. The instructions include a template, a parts list and a list of tools necessary to complete the installation. Read the IMPORTANT SAFETY INSTRUCTIONS and the instructions that fit your situation before beginning installation.

WARNING

1.Range must be secured by ANTI-TIP bracket supplied.

2.See instructions to install (supplied with bracket).

3.Unless properly installed, range could be tipped by stepping or sitting on door. Injury might result from spilled hot liquids or from range itself.

Typical installation of Anti-Tip bracket

Attachment to Wall

Bracket

\/\\\l/////\\\\\

STEP 7

 

LEVELING THE RANGE

 

The range must be level. Leveling feet are locate

 

at each corner of the base of the range. Remove

 

the storage drawer or kick panel (depending on

 

your model) and using channel locks, rotate the

 

leveling feet in and out as required to level the

 

range. (For instructions on how to remove and

 

replace the storage drawer or the kick panel, set

 

the Cleaning Under the Range section in Care

 

and Cleaning.) On some models, there are plasti

 

covers which may be removed for easy

 

adjustment (just squeeze and pull).

 

One of the rear leveling feet will engage the

 

ANTI-TIP bracket (allow for some side to side

 

adjustment). Allow a minimum clearance of 1/8”

 

between the range and the leveling foot that is tf

 

be installed into the ANTI-TIP bracket.

 

Check the range for proper installation into the

 

ANTI-TIP bracket (after the range has been

 

properly installed) by grasping the edges of the

 

REAR burner holes and carefully attempting to

 

tilt the range forward.

 

STEP 8

I

FINAL CHECK

Be sure all switches are in the “off” position

I

before leaving the range.

 

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Se and Care&Installation Guide Help US Help YOU If YOU Need ServiceRead this book carefully Important Safety Notice Important Safety Instructions Self-Cleaning OvenOven Surface Cooking UnitsCan cause hot fat to bubble up and over sides Features of Your Range ’eature Indew i Nfi all nxiel~ have all features Explained26,28 16, 18, 19How to Set the Controls Heat Setting GuideSurface Cooking Cooking TipsDeep Fat Frying Wok CookingObserve the Following Points in Canning Canning should be done on surface units onlyAutomatic Timer and Clock To Set the Clock Minute TimerQuestions and Answers Can I use the Minute Timer during oven cooking?Oven Controls Before Using Your OvenOven Interior Shelves Using Your Oven Adjusting Oven ThermostatHow to Set Your Range for Baking To adjust the thermostat knobHow to Set Delay Start and Stop How to Set Immediate Start and Automatic StopTimed Baking Pan Placement Oven ShelvesPreheating Baking PansBaking Guides PiesCakes Aluminum FoilRoasting Frozen RoastsRoasting Guide Why is my roast crumbling when I try to carve it?Doneness Why are my meats not turning out as brown as they should? BroilingUse of Aluminum Foil Questions & AnswersBroiling Guide Slash fatOperating the SELF-CLEANING Oven Before a Clean CycleHow to Set Oven for Cleaning Normal cleaning time 3 hoursAfter a Clean Cycle Lift-Up Cooktop on some models Cooktop SurfaceCalrod Surface Units Drip Pans Cooktop Surface Lamp on some modelsOven Vent To removeControl Panel and Knobs Broiler Pan and RackOven Lamp Replacement on some models Metal PartsGlass Surfaces Ift-off Oven DoorInstallation Instructions NUIT3 This appliance must be properly groundedStep Preimre for Electrical Connection Installation Instructions Aluminum Wiring Connect length of copper building wire toOven will Problem Solver Wdll Be There Warranty
Top Page Image Contents