GE JGBS02, LGB128 installation instructions Oven Air Vents, Removable Storage Drawer on some models

Page 25

www.GEAppliances.com

Oven Shelves

Clean the shelves with an abrasive cleanser or steel wool. After cleaning, rinse the shelves with clean water and dry with a clean cloth.

Lift-Up Cooktop (on models with standard twin burners)

Clean the area under the cooktop often. Built-up soil, especially grease, may catch on fire.

To make cleaning easier, the cooktop may be lifted up.

To raise the cooktop:

1.Be sure burners are turned off.

2.Remove the grates.

3.Grasp the two front burner wells and lift up.

Some models have dual support rods that will hold the cooktop up while you clean underneath it.

Clean under the cooktop with hot, soapy water and a clean cloth. If you removed your surface burners while cleaning, make sure they are properly seated when replacing them.

After cleaning, lower the cooktop (be careful not

to pinch your fingers). Lower cooktop gently to avoid blowing out pilot flames (on standing pilot models).

Oven Air Vents

Never block the vents (air openings) of the range.

 

They provide the air inlet and outlet that are necessary

 

for the range to operate properly with correct

 

combustion. Air openings are located at the rear of the

 

cooktop, at the top and bottom of the oven door, and at

 

the bottom of the range, under the kick panel, storage

 

drawer or broiler drawer (depending on the model).

Vent appearance and location vary.

Care and Cleaning

Removable Storage Drawer (on some models)

The storage drawer is a good place to store cookware and bakeware. Do not store plastics and flammable material in the drawer.

The storage drawer may be removed for cleaning under the range. Clean the storage drawer with a damp cloth or sponge. Never use harsh abrasives or scouring pads.

To remove the storage drawer:

1.Pull the drawer straight

out until it stops.

2. Tilt the front of the drawer up and free of the range.

To replace the storage drawer:

1.Set the stops on the back of the drawer over the stops in the range.

2.Slide the drawer evenly and straight back, so that the rails in the range are engaged.

Removable Kick Panel (on some models)

The kick panel may be removed for cleaning under the range.

To remove, lift up the bottom of the panel slightly to disengage the panel from the tabs at the base of the range. Pull the bottom of the panel forward until the spring clips are released at the top of the panel.

To replace, insert the two slots at the bottom of the panel onto the two tabs at the base of the range and push the top of the panel forward to engage the spring clips.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents RangesXL44 Gas Help US Help YOU… Save time and money. Before you request service…Read this manual carefully If you received a damaged range…When You Get Your Range Important Safety InstructionsUsing Your Range Do not allow anyone to climb, stand or Surface CookingSave These INSTRUCTIONS5 Cleaning Your RangeBaking, Broiling and Roasting Features and appearance vary Features of Your RangeSurface Burners, Grates and Drip Pans on some models SeeOven Control Oven Shelves with Stop-Locks Number of shelves variesSurface Burner Controls Surface CookingBefore Lighting a Burner To Light a Surface BurnerTop-of-Range Cookware How to Select Flame SizeDo not use a wok on any other support ring To Set the Timer Clock and TimerTo Change or Cancel the Timer Setting Display Clock While Timer Is OperatingUsing Your Oven Shelf Positions Oven ShelvesOven Vents Baking How to Set Your Range for BakingTo avoid possible burns, place the shelves Type of Food Shelf PositionPreheating Pan PlacementBaking Guides CookiesCakes PiesBaking Pans Don’t PeekTo Adjust the Thermostat Adjust the Oven ThermostatType of Margarine Will Affect Baking Performance Use of Aluminum Foil RoastingDual Shelf Cooking Roasting Guide Questions and AnswersFrozen Roasts Broiling Why are my meats not turning out as brown as they should?Should I salt the meat before broiling? Ground Beef Broiling GuideStandard Twin Burners on some models Care and CleaningFor proper ignition Sealed Burner Assemblies on some modelsCooktop Surface Burner GratesOven Bottom Control Panel and Knobs Oven Light Bulb on some modelsRemovable Broiler Drawer on some models Broiler Pan and GridRemovable Storage Drawer on some models Oven Air VentsRemovable Kick Panel on some models Outside of door Lift-Off Oven DoorStainless Steel Surfaces on some models For Your Safety Installation InstructionsImportant Safety Instructions General Provide Adequate GAS Supply Connect the Range to GAS Extension Cord Cautions Electrical RequirementsIMPORTANT-Please read carefully Electrical Connections Seal the Openings Yellow flames Electric Ignition ModelsTo remove the oven bottom To remove the broiler drawer Leveling legs can be ⁄ 8 ″ Converting to LP GAS Page Problem Possible Cause QUESTIONS? Before YOU Call for SERVICE…Do It Yourself section We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Consumer Support GE Appliances Website Warranty

JGBS02, LGB128 specifications

The GE LGB128 and JGBS02 are two advanced gas turbine models that represent the cutting edge of power generation technology. These turbines are engineered by General Electric, a leader in energy solutions. Both models are designed to enhance efficiency, reduce emissions, and provide reliable power for various applications.

The GE LGB128 is a robust gas turbine characterized by its modular design, which simplifies maintenance and installation processes. This turbine is known for its high efficiency, with a thermal efficiency rating that can reach above 60%. The LGB128 utilizes advanced aerodynamics in its compressor and turbine sections, optimizing performance across a wide range of operating conditions.

One of the key features of the LGB128 is its use of advanced materials and coatings that enhance durability and performance. The turbine blades are crafted from state-of-the-art alloys that can withstand extremely high temperatures, ensuring longevity and reliability. Furthermore, the LGB128 is equipped with sophisticated control systems that leverage machine learning algorithms, enabling real-time optimization of operation and maintenance schedules.

On the other hand, the GE JGBS02 gas turbine is recognized for its versatility and adaptability in various power generation applications. This model is particularly notable for its ability to utilize multiple fuel sources, including natural gas and biogas, which gives it a significant advantage in sustainability. The JGBS02 incorporates advanced combustion technologies that minimize nitrogen oxide (NOx) emissions, making it an environmentally friendly choice for both industrial and utility-scale power generation.

A prominent characteristic of the JGBS02 is its compact design, allowing for flexible installation in limited spaces. This feature is crucial for projects where space is a constraint. Additionally, the turbine is equipped with an intelligent monitoring system that continuously assesses performance metrics, providing operators with valuable insights into efficiency and potential maintenance needs.

Both the LGB128 and JGBS02 are designed to provide reliable performance in today's demanding energy landscape. Their capabilities make them suitable for various applications, including combined cycle power plants and peak shaving operations. As the world pivots toward cleaner energy solutions, these GE turbines embody the technological advancements necessary for fostering a sustainable future in power generation. With their commitment to efficiency, durability, and environmental responsibility, the LGB128 and JGBS02 stand at the forefront of modern energy technology.
Top Page Image Contents