GE JGSC12 HOW does this Cooktop Compare Your OLD ONE?, Surface Cooking, Electric Ignition

		HOW DOES THIS COOKTOP COMPARE					—
			TO	YOUR	OLD ONE?
	Your new cooktop has gas burners. If you are used				The best types of cookware to use, plus heat-up and
	to cooking with induction or other electric surface				cool-down times, depend upon the type of burner or
	units, you will notice some differences when you use				surface unit you have.
	gas burners.				The following chart will help you to understand the
					differences between gas burner cooktops and any
					other type of cooktop you may have used in the past.
	Type of Cooktop	,	Description	How it Works
	Gas Burners
			I Remlaror sealed	Flames heat the pans directly. Pan flatness is not critical to cooking results, but
	.=— .		gas: burners use	pans should be well balanced. Gas burners heat the pan right away and change
	‘ ,\ 4		either LP gas	heat settings right away. When you turn the control off, cooking stops right away.
*			or natural gas.
	Radiant		Electric coils	Heat travels to the glass surface and then to the cookware, so pans must be		tlat on
	(Glass Ceramic)		under a glass-	the bottom for good cooking results. The glass cooktop stays hot enough to
	Cooktop		ceramic cooktop.	continue cooking after it is turned off. Remove the pan from the surface unit it’
	o			you want cooking to stop.
	Induction		High frequency	Pans must be made of ferrous metals (metal that attracts a magnet). Heat is
	\\lllll//,,,,		induction coils	produced by a magnetic circuit between the coil and the pan. Heats up right away
$$@#
-%,,,,,,,,,, .			under a glass	and changes heat settings right away, like a gas cooktop. After turning the control
			surface.	off, the glass cooktop is hot from the heat of the pan, but cooking stops right away,
	Electric Coil		Flattened metal	Heats by direct contact with the pan and by heating the air under the pan. For best
			tubing containing	cooking results, use good quality pans. Electric coils are more forgiving of
	‘\”@		electric resistance	warped pans than radiant or solid disks. Heats up quickly but does not change —
			wire suspended	heat settings as quickly as gas or induction. Electric coils stay hot enough to
			over a drip pan.	continue cooking for a short time after they are turned off.
	Solid Disk		Solid cast iron	Heats by direct contact with the pan, so pans must be flat on the bottom for good
~			disk sealed to the	cooking results. Heats up and cools down more slowly than electric coils. The
			cooktop surface.	disk stays hot enough to continue cooking after it is turned off. Remove the pan
	oc.
				from the solid disk if you want the cooking to stop.

SURFACE COOKING

Electric Ignition

Your surface burners are lighted by electric ignition, eliminating the need for standing pilot lights with constantly burning flames.

In case of a power failure, you can light the surface burners on your range with a match. Hold a lighted match to the burner, then turn the knob to the LITE position. Use extreme caution when lighting burners in this manner.

Surface burners in use when an electrical power failure occurs will continue to operate normally.

Surface Burner Controls

The knobs that turn the surface burners on and off are located on the lower control panel in front of the burners.

The two knobs on the left control the left front and — left rear burners. The two knobs on the right control

the right front and right rear burners.

8