Care and cleaning of the range.
Oven Shelves
If your oven is equipped with nickel oven shelves, they should be removed from the oven before beginning the
To clean the nickel shelves, use an abrasive cleanser. After cleaning, rinse the shelves with clean water and dry with a clean cloth. If the shelves ever become hard to slide, wipe the shelf edges or oven shelf supports with vegetable oil.
If your oven is equipped with gray porcelain- coated shelves, they may be cleaned in the oven during the
They may also be cleaned by using an abrasive cleanser. After cleaning, rinse the shelves with clean water and dry with a clean cloth. If the shelves ever become hard to slide, wipe the shelf edges or oven shelf supports with vegetable oil.
Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions
Wire cover holder.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely.
The oven light bulb is covered with a removable glass cover that is held in place with a
To remove:
Hold a hand under the cover so it doesn’t fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
Do not touch hot bulb with a wet cloth. Replace bulb with a
To replace cover:
Place it into the groove of the light receptacle. Pull the wire forward to the center of the cover until it snaps into place. When in place, the wire holds the cover firmly. Be certain the wire
is in the depression in the center of the cover.
Connect electrical power to the range.
38