GE JGB902 installation instructions ANTI-TIP Device, Location

Page 42

Installation Instructions

WARNING!

ANTI-TIP DEVICE

All ranges can tip and injury could result.

To prevent accidental tipping of the range, attach an approved Anti-Tip device to the wall. (See Installing the Anti-Tip Device in this section.) To check if the device is installed and engaged properly, carefully tip the range forward. The Anti-Tip device should engage and prevent the range from tipping over.

If you pull the range out from the wall for any reason, make sure the Anti-Tip device is engaged when you push the range back against the wall.

For your safety, never use your range for warming or heating the room. Your oven and cooktop are not designed to heat your kitchen. Top burners should not be operated without cookware on the grate. Such abuse could result in fire and damage to your range and will void your warranty.

Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Explosions or fires could result.

Do not use oven for a storage area. Items stored in the oven can ignite.

Do not let cooking grease or other flammable materials accumulate in or near the range.

LOCATION

Do not locate the range where it may be subject to strong drafts. Any openings in the floor or wall behind the range should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are not obstructed by carpeting or woodwork.

Your range, like many other household items, is heavy and can settle into soft floor coverings such as cushioned vinyl or carpeting. Use care when moving the range on this type of flooring. It is recommended that the following simple and inexpensive instructions be followed to protect your floor.

The range should be installed on a sheet of plywood (or similar material). When the floor covering ends at the front of the range, the area that the range will rest on should be built up with plywood to the same level or higher than the floor covering.

This will allow the range to be moved for cleaning or servicing. Also, make sure your floor covering will withstand 180°F. (See the Installation Safety Instructions section.)

Make sure the wall coverings around your range can withstand the heat generated (up to 200°F) by the range. (See the Installation Safety Instructions section.)

IMPORTANT!

Remove all tape and packaging. Make sure the burners are properly seated and level.

Take the accessory pack out of the oven and/or drawer.

Check to be sure that no range parts have come loose during shipping.

42

Image 42
Contents Installation Instructions Write the model and serial numbers here Model # Serial #Consumer Support Troubleshooting All ranges can tip and injury could resultImportant Safety Notice Safety Instructions Operating InstructionsInstructions Surface Burners Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions SafetyTroubleshooting Tips Consumer SupportInstructions Using the gas surface burnersTroubleshooting Tips Installation ConsumerSafety Installation Instructions Troubleshooting TipsConsumer Support Using the oven controls Oven Control, Clock and Timer Features on some modelsTroubleshooting Tips Consumer Support Oven Light Pad on some modelsTroubleshooting Tips Using the ovenInstallation Instructions Operating Consumer SupportAluminum Foil How to Set the Oven for Baking or RoastingPreheating and Pan Placement Oven MoistureBroiling Guide How to Set the Oven for BroilingBroiling Guide HI BroilUsing the clock and timer Installation InstructionsConsumer Service How to Set an Immediate Start and Automatic Stop Using the timed baking and roasting featuresConsumer Support Troubleshooting Tips Installation How to Set a Delayed Start and Automatic StopUsing the probe. on some models How to Set the Oven For Cooking When Using the ProbeInstallation Instructions Using the convection oven. on some models Installation Instructions Operating Instructions SafetyConsumer Support Troubleshooting Tips Troubleshooting Tips Consumer Support How to Set the Oven for Convection Baking or RoastingMulti-Shelf Baking Operating Instructions Safety Touch the Convection Roast padConvection Roasting Guide MeatsConsumer Support Troubleshooting Tips Using the timed convection baking features. on some modelsSafety Instructions Installation Instructions Operating InstructionsFahrenheit or Celsius Temperature Selection Special features of your oven controlSafety Instructions Hour Shut-OffHour, 24-Hour or Clock Blackout Control Lockout on some modelsCook and Hold Cooking function is finishedHow to Set for Regular Baking/Roasting Using the Sabbath FeatureInstructions Troubleshooting Tips Consumer Support Safety InstructionsHow to Exit the Sabbath Feature To Adjust the Thermostat Adjust the oven thermostat-Do it yourselfSafety Instructions Type of margarine will affect baking performanceWarming drawer cannot be used during a self-clean cycle Using the electric warming drawer. on some modelsWhen Using the Warming Drawer To Use the Warming DrawerTemperature Selection Chart Instructions Troubleshooting Tips Consumer SupportInstructions Operating Instructions Installation To Crisp Stale ItemsBefore a Clean Cycle Using the self-cleaning ovenConsumer Support Troubleshooting Tips Installation How to Set the Oven for CleaningAfter a Clean Cycle How to Delay the Start of CleaningCare and cleaning of the range Sealed Burner AssembliesTips Consumer Support Burner Caps and HeadsBurner Grates Consumer Support TroubleshootingCleaning Cooktop SurfaceOven Bottom Troubleshooting TipsLift-Off Oven Door Broiler Pan and GridRemovable Drawer To remove the drawerTo replace the drawer Oven Air Vents Safety Instructions OperatingUnlock the touch pads after cleaning Upper Control PanelTo remove Oven Light ReplacementOven Shelves Do not remove any screws to remove the coverFor Your Safety Tools YOU will NeedMaterials YOU MAY Need Installation Instructions Electrical Connections in this sectionDimensions and Clearances Minimum Wall on Either sideANTI-TIP Device LocationProvide Adequate GAS Supply Connect the Range to GASGAS Pipe and Electrical Outlet Locations Flexible Connector Hookup Rigid Pipe Hookup OptionsElectrical Connections Electrical RequirementsCheck Ignition of Surface Burners Seal the OpeningsCheck Ignition of Oven Burner Leveling the Range To remove the oven bottomInstalling the ANTI-TIP Device When ALL Hookups are CompletedBefore you call for service… Problem Possible Causes What To DoClock and timer Control signals afterOven temperature Entering cooking timeClean cycle See the Using the self-cleaning oven sectionAfter a clean cycle Oven not clean after a Is on when you wantDisplay flashes Power outageDisplay goes blank Unable to getAccessories Looking For Something More?We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Troubleshooting Tips Consumer Support Operating Instructions Installation InstructionsGE Will Replace Instructions Safety InstructionsOperating What GE Will Not CoverCamco Will Replace Safety Instructions OperatingInstructions Installation Instructions What Camco Will Not CoverGE Appliances Website Schedule Service Consumer Support