Amana W10130752B installation instructions Complete Conversion, Natural Gas Conversion

Page 14

Complete Conversion

1.Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.

2.Turn the manual shutoff valve in the gas supply line to the open position.

3.Refer to “Check Operation” in the “Electronic Ignition System” section for proper burner ignition, operation and burner flame adjustments.

IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.

Checking for proper cooktop and oven burner flames is very important. The small inner cone should have a very distinct blue flame ¼" to ½" (0.64 cm to 0.13 cm) long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip.

4.Close the oven door and turn the knob to “OFF.”

5.Refer to the “Complete Installation” section to complete this procedure.

Natural Gas Conversion

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti-tip bracket to rear range foot.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death or serious burns to children and adults.

To Convert Gas Pressure Regulator

1.Turn manual shutoff valve to the “closed” position.

B

A

C

A. To range

B. Manual shutoff valve “closed” position

C. Gas supply line

2.Unplug range or disconnect power.

3.Open broiler door and remove broiler pan. The gas pressure regulator is located in the back right hand corner of the broiler compartment.

A

A. Gas pressure regulator

IMPORTANT: Do not remove the gas pressure regulator.

NOTE: Do not remove the spring beneath the cap.

4.Remove the cap from the gas pressure regulator using a flat-blade screwdriver.

A

A.Cap

5.Turn the cap over so that N or NAT is visible.

A

A. Cap

6.Reinstall the cap.

14

Image 14
Contents Installation Instructions 30 76.2 CM Freestanding GAS Ranges Range Safety Your safety and the safety of others are very importantLocation Requirements Installation RequirementsTools and Parts Mobile home installations require Mobile Home Additional Installation RequirementsProduct Dimensions Cabinet Dimensions Type of Gas Electrical RequirementsGas Supply Requirements Natural gasGas Pressure Regulator Gas Supply Pressure TestingGas Supply Line Burner Input RequirementsUnpack Range Installation InstructionsInstall Anti-Tip Bracket Typical flexible connection Make Gas ConnectionTypical rigid pipe connection Complete Connection Verify Anti-Tip Bracket LocationLevel Range Electronic Ignition System Initial lighting and gas flame adjustmentsIf the low flame needs adjusting Check Operation of Cooktop BurnersIf you need Assistance or Service Complete InstallationIf the flame needs adjusting If range does not operate, check the followingTo Convert Gas Pressure Regulator GAS ConversionsLP Gas Conversion To Convert Surface Burners To Convert Oven BurnerComplete Conversion Natural Gas ConversionStd Burner W10130752B