AEG C41022GN manual Special maintenance, Removing the oven door, Cleaning the inside oven fan

Instructions for the user

11. Special maintenance

Periodically, it is necessary to maintain or replace some parts that are subject to wear and tear. Specific instructions are given below for each type of maintenance.

Before carrying out maintenance, switch off the power supply to the appliance and close the gas tap.

11.1 Removing the oven door

In order to clean the oven door more thoroughly, we recommend removing it as follows:

•open the door completely;

•hook the rings A onto the appropriate seats in the hinges (Fig. A);

•lift the door slightly and remove it (Fig. B);

•place the door on a horizontal surface;

•unscrew the screw B using a screwdriver and remove the tab C (Fig. C);

•clean the glass D (Fig. C) and door components as described in section “10.8.1 Cleaning the oven door”;

•afterwards, follow the removal instructions in reverse order.

11.2 Cleaning the inside oven fan

The fan of the oven should be cleaned regularly. To disassemble the fan proceed as follows:

•Make sure that the power supply to the appliance is switched off;

•Remove all inside components (dripping pan, shelves);

•Unscrew and remove the two washers A;

•Remove the protection B of the fan D from the two joint pins E;

•Unscrew the washer C from the fan (unscrew rightwards by using a coin);

•Remove the fan D and clean it by immersing it in a solution of warm water and non-abrasive detergent (do not use any metallic sponge nor powder-detergent).Rinse and dry carefully;

•Afterwards, follow the disassembly instructions in reverse order.