AEG C41022GN manual Using the cooking hob, Switching on the burners, Switching off the burners

Page 13

Instructions for the user

4. Using the cooking hob

Make sure that the flame caps, the burner caps and the pan supports are fitted correctly.

During normal operations, the appliance heats up considerably. Caution should therefore be used. Do not allow children to approach the appliance. Do not leave the cooking hob unattended while it is on.

4.1Switching on the burners

All the hob burner knobs have the following symbols:

OFF

high flame

low flame

The low flame setting is found by turning the knob anticlockwise all the way. All intermediate settings must be selected between the high flame and low flame, never between high flame and closed.

4.1.1One-touch lighting

The hob burners are equipped with a "one-touch" lighting system. To switch on one of the burners, press the knob corresponding to the required burner and turn it anticlockwise to the low setting . Hold down the knob to activate the automatic "one-touch" lighting system. When the burner is on, hold down the knob for approximately 10 seconds, to allow the safety valve to open. In the event of a power cut, the burner can also be lit with a match (see section “4.1.2 Manual lighting”).

Should the burner switch off accidentally, the safety thermocouple blocks the gas flow, even when the tap is open.

The device should not been activated for longer than 15 seconds. If after that time it fails to operate stop pressing the knob, open the window and wait 1 minute before trying again. In case the flame goes out accidentally turn off the knob and do not try to switch on the burner for at least

1minute.

4.1.2Manual lighting

To light one of the burners, move a lit match towards the burner, press the corresponding knob and turn it anticlockwise to the minimum setting . Release the knob.

4.2Switching off the burners

At the end of the cooking, return the knob to position .

Image 13

Contents C41022G C41022GN C41022V Page Contents Classes of Appliances InstallationDo not Attempt to Repair the Appliance General information Technical serviceDescription of controls Layout of Burners Description of symbolsFront panel Control Panel Description of HOB Control KnobDescription of FRY-TOP Control Knob Layout of Heating Elements Description of symbolsDescription of Symbols on Auxiliary Electric Oven Knob Description of Symbols on the Function Switch KnobDescription of Auxiliary Electric Oven Knob HOW to SET the Countdown Electronic Timer KEYSET the Time of DAY Setting the Oven Timer Control To Cancel the Countdown# to SET the Timer to Switch on and OFF Automatically To Cancel AN Automatic Programme $ to SET the Timer to Switch OFF onlyTo Return the Appliance to Manual Things to NoteSwitching on the burners Using the cooking hobSwitching off the burners One-touch lightingBefore switching on the fry-top Using the fry-top If fittedSwitching on Heat Setting GuideGeneral warnings Using the ceramic hobSwitching on the oven for the first time Using the electric ovenTraditional cooking Convection cookingCooking with the ventilated grill Switching off the ovenCooking with the grill DefrostingSwitching on the auxiliary oven for the first time Using the auxiliary oven with natural convectionSwitching off the auxiliary oven Cooking with the grill auxiliary ovenSuggestions for using the fry-top correctly Suggestions for using the hob burners correctlySuggestions for using the ceramic hob correctly Suggestions for using the oven correctlyCooking with the grill Convection cookingCooking with the ventilated grill Cooking meat and fishTable of Convection and Traditional Cooking Times Recommended cooking tablesCleaning stainless steel surfaces Cleaning and maintenanceCleaning enamelled surfaces Cleaning the knobs and the control panelCleaning the fry-top Cleaning the igniter plugs and thermocouplesCleaning the ceramic hob Cleaning the ovenReplacing the oven light bulb Voltage 230 V / 50 Hz Power 15 W AttachmentCleaning the inside oven fan Special maintenanceRemoving the oven door Dimensions of the Cookers InstallationElectric connection Rating plate must never be removedType of power supply Electric power cable sectionVentilation requirements Power consumption of the ceramic hobReplacing the electric cable Gas connection Stability chain Gas regulations Connecting to LPGMinimum flow of valved cooking hob taps Minimum flow of non-valved cooking hob tapsPositioning and levelling the cooker Final operationsCustomer Care Department Service and Spare PartsStandard guarantee conditions Guarantee ConditionsEuropean Guarantee Page From the Electrolux Group. The world’s No choice