Heartland Bakeware 9200/7200 manual Air Shutter Adjustment oven burner only, Oven Burner Assembly

Page 31

Air Shutter Adjustment (oven burner only)

The quality of the flame can be changed by adjusting the air shutters. Factory setting on the air shutter is 0.40" (10.6mm). (see figure 29)

Reduce the shutter opening if:
• the flame appears unsteady
• is not burning all the way around
• is noisy like a small blow torch.
Increase the shutter opening if:
• the flame has yellow tips
• there is no sharp blue cone
• soot appears on the bottom of cooking pans.	air shutter adjustment
	air shutter adjustment
	Figure 29

The air shutter is adjusted by loosening the locking screw and rotating the shutter to allow more or less air into the tube. The centred position is usually about right. Tighten the screw, replace the assembly and check the flame pattern.

Oven Burner Assembly

The oven burner assembly is visible and accessible for servicing when the oven bottom panel is removed. The burner assembly is made up of several components as shown below.

thermocouple

burner

igniter

Oven burner assembly

Figure 30

IMPORTANT

The thermocouple and igniter positioning is very important to the operation of the oven. These two items must be checked before putting the appli- ance into operation. (see figure 31)

NOTE: Before putting the 7200 /9200 Gas Range into service, be
sure that all the setup procedures recommended in this manual
have been completed.	Figure 31

31

Image 31

Contents Model 9200 Model Installation and Operating InstructionsREV When moving range for service or cleaning For Your SafetyWhat to do if YOU Smell GAS Gas Models 9200/7200 Table of Contents Positioning the Range Assembly of Exhaust Hood to RangeExhaust Hood Electrical Connection Electrical InstallationExhaust Hood Ventless InstallationVented Installation, Tools, Material, and Dimensions Tools required to install vented hoodModel Installation of DuctingInstallation through an outside wall Installation through an attic to an outside wallGas Line Installation Venting Safety GuidelinesModel How to StepsAppliances installed in the state of Massachusetts SafetyRough Measurements Model DimensionsAppliances 47-1/2 101 cm 121 cm RoughExhaust Hood Safety Important Safety InstructionsOven Safety Cooking Controls Sealed Burner Features see figOther Features see fig Oven FeaturesModel Control Panel Control Panel LayoutLighting the Top Burners Top Burner OperationBroil Oven CookingOven Lighting Range ThermostatManually Lighting the Top Burners Power Failure OperationManually Lighting the Oven Burner Signal Clock / TimerFunctions Power on Reset minute minderBaking Guide Cooking GuideMeat Roasting Guide Broiling GuideKeeping it clean Care and Cleaning PorcelainSurface Burners Oven CleaningNickel-Plated Trim Oven and Cabinet Light ReplacementRack Supports Interior Oven RackRemoval of Oven Door Broiling Pan BroilingBurner Setup & Adjustment Setup and TroubleshootingOven Burner Assembly Air Shutter Adjustment oven burner onlyOven Burner Problem Cause Remedy Spark IgnitionConversion Kits and Information Model Products See our complete line of kitchen appliances7200/9200 Parts Diagram Model 7200/9200 Range Parts List Model 7200/9200 Technical Data Wiring Diagrams