Heartland Bakeware 9200/7200 manual Assembly of Exhaust Hood to Range, Positioning the Range

Page 6

Assembly of Exhaust Hood to Range

See the manual entitled "Cabinet

Assembly Instructions for Gas, Electric, Combination and Wood Stoves" which is included with the cabinet .

Figure 1

Positioning the Range

1.When the range is fully assembled, recheck all electrical connections especially between the exhaust hood and the back of the range. As well, check that all nuts and bolts have been tight- ened.

2.Ensure teflon gliders and flooring are clean.

3.Caution: On flooring with very rough surfaces or deep, large grooves the appliance may have to be lifted and slowly slid into position.

4.Put both hands on the trim and carefully push the range into place, make sure floor is clear of all debris. Don't forget to plug in the main power cord and the exhaust hood power cable before the range is in its final position. See cabinet installation instructions.

5.To level the range, simply adjust the levelling screws with teflon pads located at the bottom of each leg. Using a 5/16” (8 mm) open-end wrench turn the adjusting screw clockwise to raise up the corner, and counter-clockwise to lower the corner. (Don't forget the teflon glider should extend beyond the bottom of the leg by approximately 1/8"-1/4")

6.Note: On soft kitchen flooring, the weight of the stove may cause slight depressions in the flooring. When the range is in position and levelled, you may want to place coasters under the teflon gliders of each leg, to protect the floor. Remove the coasters when moving the range for cleaning or servicing.

6

Image 6
Contents Installation and Operating Instructions Model 9200 ModelREV For Your Safety When moving range for service or cleaningWhat to do if YOU Smell GAS Gas Models 9200/7200 Table of Contents Assembly of Exhaust Hood to Range Positioning the RangeElectrical Installation Exhaust Hood Electrical ConnectionTools required to install vented hood Ventless InstallationVented Installation, Tools, Material, and Dimensions Exhaust HoodInstallation through an attic to an outside wall Installation of DuctingInstallation through an outside wall ModelVenting Safety Guidelines Gas Line InstallationSafety How to StepsAppliances installed in the state of Massachusetts ModelModel Dimensions Rough MeasurementsAppliances Rough 47-1/2 101 cm 121 cmImportant Safety Instructions Exhaust Hood SafetyOven Safety Sealed Burner Features see fig Cooking ControlsOven Features Other Features see figControl Panel Layout Model Control PanelTop Burner Operation Lighting the Top BurnersRange Thermostat Oven CookingOven Lighting BroilPower Failure Operation Manually Lighting the Top BurnersManually Lighting the Oven Burner Reset minute minder Clock / TimerFunctions Power on SignalBroiling Guide Cooking GuideMeat Roasting Guide Baking GuideCare and Cleaning Porcelain Keeping it cleanOven Cleaning Surface BurnersOven and Cabinet Light Replacement Nickel-Plated TrimInterior Oven Rack Rack SupportsRemoval of Oven Door Broiling Broiling PanSetup and Troubleshooting Burner Setup & AdjustmentAir Shutter Adjustment oven burner only Oven Burner AssemblyProblem Cause Remedy Spark Ignition Oven BurnerConversion Kits and Information Products See our complete line of kitchen appliances Model7200/9200 Parts Diagram Model 7200/9200 Range Parts List Model 7200/9200 Wiring Diagrams Technical Data