FITTING THE EDW294E ONE-PIECE CUSTOM DOOR PANEL
Model EDW294E can only be installed with a
To order a
White 750163400
Black 750163600
Bisque 750163700
Stainless Steel 750163800
ITEMS PROVIDED WITH THE ONE-PIECE DOOR PANELS
These items are supplied with the doors:
←
←
←Door handle
←Handle support bracket
←Two 1/2” machine screws for handle
←Two 1/2” sheet metal screws for toe kick
INSTALLING THE ONE-PIECE CUSTOM DOOR PANEL
Before fitting the custom panel, the dishwasher must be installed underneath the cabinet.
For this installation, we recommend that you install the 2” fill strip (see page 6) that comes with the unit to hide the top of the dishwasher and further reduce water noise.
NOTE: Do not fasten the dishwasher to the cabinet until after you have installed the door panel.
1.Remove the custom panel and parts from the packaging.
2.Move the insulation on the back of the custom panel.
3.Slide the handle support bracket to the inside top of the panel.
4.Insert the screws through the support bracket and the panel.
5.Fit the door handle to the screws and secure tightly.
6.Remove the rubber gaskets from inside the dishwasher door and discard.
7.Remove the second and fourth screws from the inside top of the dishwasher door (as illustrated) and discard.
8.With the door slightly open, position the panel with the holes in alignment with the door holes and secure it in place with
9.Insert the
10.Loosen the clamp on one side enough to align the screws with the holes in the panel.
11.Secure the screws.
12.Repeat steps 9 and 10 for the other side.
13.Close the door and, if necessary, adjust for square by adjusting the front levelling legs for proper height clearance.
14. Fasten the dishwasher to the cabinet (see page 9). | With this installation, |
| the custom panel |
| extends |
| inches above the |
| dishwasher control |
| panel, as illustrated. |
ENGLISH
13