ADJUSTING THE LEVELING LEGS
You should adjust the levelling legs to within 1/8” of the opening height. The four leveling legs should be adjusted by unscrewing the leg out to the length required. When the feet are properly adjusted, tighten the locking nuts to the base pan.
(The machine may have an inclination of 2° maximum without affecting its performance.)
Levelling leg
WARNING! Never lay the dishwasher on its front or side. When necessary, lay the unit on its back.
It is advisable to lay the unit on a tarp or blanket so as not to scratch or damage the floor or the dishwasher.
*Use caution when standing the dishwasher up so you do not break the legs.
Locking nut
MOVING THE MACHINE INTO PLACE
WARNING! Make sure you put the slides cups under the legs to prevent damaging the floor or unit when you slide it into place (see page 5).
1.Remove the toe kick from the top of the unit and set it aside.
2.Remove the zip tie holding the hoses and power supply cord in place on the back of the unit as illustrated at right.
3.Position the unit in front of the cabinet opening.
4.Weave the drain line through the U shaped High Loop bracket and attach that bracket to the back of the unit or the surrounding cabinets as illustrated on page 10 of this manual.
5.Start to feed the water and drain lines, as well as the power cord (if necessary) into the access hole in the cabinet.
6.Grip the unit at the top or side edges and gently slide the unit into the dishwasher opening using the slide cups provided with the unit under the rear legs.
WARNING! Never use your knee or shoulder to push the unit in place. You could damage the dishwasher.
7. Check the level and make adjustments if necessary. (See above.)
WARNING! Be careful of sharp edges.
OPENING THE EDW294E CUSTOM DOOR
To open the door panel on the EDW294E, insert your fingers into the rectangular slots on each side of the door and pull.
ENGLISH
7