Eurotech Appliances EDW274E Cabinet Opening Dimensions, Moisture Barrier, Measurements, Metric

CABINET OPENING DIMENSIONS

	Measurements
	US	Metric
Height	32 1/4"–35"	820–890 mm
Width	24"	610 mm
Depth	23-15/16"	608 mm

The electrical and water supplies should enter through the area indicated by the shading on the illustration at right. They should come through the right side of the machine, a maximum of 2” (50 mm) from the back wall and 6-1/4” to 8-1/4” (159–210 mm) from the floor, depending on the underneath cabinet height.

After determining where the water supply line will enter under the sink, drill a 1-1/2" (38 mm) access hole. The water line inlet valve is on the right rear of the machine.

1/4”to35”	to890mm
32	820

MOISTURE BARRIER

Among the materials supplied with your unit are two strips of moisture resistant material (moisture barriers). One of these is intended to be affixed underneath the front edge of the countertop to prevent possible moisture damage. The other is for a custom wood panel (EDW294E only).

If you intend to use a moisture barrier on the cabinet, you should affix it to the cabinet before you install the dishwasher.

INSTALLING THE TOP FILL STRIP ON MODEL EDW294E

If you have Model EDW294E, you will need to install the fill strip before you place the dishwasher inside the cabinet. To do this, follow the instructions below:

1.Center the fill strip on top of the installation lip on the front edge of the unit.

2.If the fill strip is wider than the cabinet opening, use a coarse sandpaper or straight edge hack saw to trim one end.

3.Using 2-1/2” squeeze clamps, secure the fill strip to the installation lip, as illustrated below.

4.Fasten the fill strip to the dishwasher using the four 3/4” screws supplied with the unit in the holes on the installation lip.

5.Remove the clamps.

6