Radio Shack ET-2105 manual Setting the Ringer, Setting the Dialing Mode

Page 11

Cautions:

Be careful not to short the battery pack by touching it with conducting materials, such as rings, bracelets, and keys. The battery pack or conductor might overheat and burn.

Do not open or mutilate the battery pack.

If you have trouble replacing the battery pack, take the phone to your local RadioShack store for assistance.

Setting the Ringer

OFF/ON RINGER, on the right side of the handset, controls the key- pad ringer. To have the phone ring when a call comes in, slide RINGER to ON. To turn the ringer off, slide RINGER to OFF.

When RINGER is set to OFF, the phone does not ring, but you can still make outgoing calls. If you hear an extension telephone ring, you can answer the incoming call on this phone. The CHARGE/IN USE indicator on the base and IN USE/LOW BATT on the keypad indicator flash until you answer the call.

Setting the Dialing Mode

Set TONE/PULSE on the back of the base for the type of service you have. If you are not sure which type you have, do this simple test after charging the battery pack.

1.Set TONE/PULSE to TONE before use.

2.Press TALK so the CHARGE/IN USE indicator lights then lis- ten for a dial tone.

3.Press any number other than 0 and 1.

10

Image 11
Contents Contents ET-2105 FeaturesRisk of Electric Shock Do not Open Read this Before Installation FCC Wants YOU to Know Lightning Selecting a Location PreparationConnecting the Base Connecting, Charging, Replacing the Battery Pack Page Setting the Dialing Mode Setting the RingerUsing the Belt Clip Using the EarphoneMaking and Receiving Calls OperationChanging Channels Adjusting the Keypad’s VolumeUsing Redial Using Tone Services on a Pulse Line Using MuteUsing Flash Storing a Number in Memory UsingMemory Dialing Entering a Pause in a Memory Number Dialing a Stored Number Chain Dialing Service NumbersTesting Stored Emergency Numbers Problem Suggestion TroubleshootingCare Limited One-Year Warranty