westinghouse 15
FROST PRECAUTIONS
Caution! Do not install the appliance where the temperature is below 0 °C. The manufacturer is not responsible for damage caused by frost.
MOVING THE APPLIANCE
1.Disconnect the mains plug from the mains socket.
2.Close the water tap.
3.Remove the appliance and the hoses.
4.Do not tilt the appliance during trans- port.
WHAT TO DO IF…
The appliance does not start or stops dur- ing operation.
If there is a fault, first try to find a solution to the problem yourself. Refer to following charts. If you cannot find a solution to the problem, contact your dealer or the Cus- tomer Care Centre.
With some malfunctions, the display shows an alarm code:
•
- The appliance does not fill with wa- ter
•
- The appliance does not drain the water
•
- The
Warning! Switch the appliance off before you do the suggested corrective actions.
Malfunction | Possible cause |
The appliance does | The water tap is closed. |
not fill with water |
|
| The filter in the water inlet hose is |
| blocked. |
| The installation of the water inlet |
| hose is not correct. The hose is bent |
| or squashed. |
| The water tap is blocked or restric- |
| ted with limescale. |
| The water pressure is too low. |
The appliance does | There is a blockage in the sink spi- |
not drain the water | got. |
| The installation of the water drain |
| hose is not correct. The hose is bent |
| or squashed. |
The |
|
operates |
|
The program does | The appliance door is not closed. |
not start |
|
| The START button has not been |
| pressed. |
| Mains plug is not connected. |
| The delay start is set. |
|
|
| The fuse has blown out in the |
| household fuse box |
|
|
Possible solution
Open the water tap.
Clean the filter.
Make sure that the installation is cor- rect.
Clean the water tap.
Contact your local water authority.
Clean the sink spigot.
Make sure that the installation is cor- rect.
Close the water tap and contact your Customer Care Centre.
Close the door.
Press the START button.
•Cancel the delay start.
•Wait until the countdown of the delay start is completed.
Replace the fuse.