Makita VC4710
6 Maintenance
6.1Maintenance plan
|
| After finishing work | When required |
|
|
|
|
7.2.1 | Emptying tank | |
|
|
|
|
|
7.2.2 | Emptying tank after wet suction | |
|
|
|
|
|
7.2.3 | Replacing the filter bag |
| |
|
|
|
|
7.2.4 | Replacing the disposal bag |
| |
|
|
|
|
7.2.5 | Replacing filter element |
| |
6.2Maintenance work
Any other maintenance than described in chapter 6 should be performed by Makita factory service center.
6.2.1 Emptying the tank
After emptying the tank: clean the rim of the tank and the seals in the intermediate ring and the upper sec- tion of vacuum before refitting them. If the seal or groove is dirty or dam- aged, the suction performance will be reduced.
Before reinserting the suction hose: clean the inlet fitting and hose col- lar.
A | A |
1.Be sure that the vacuum is switched off and unplugged.
2.Open the retaining clamps (A) and remove the upper sec- tion of the vacuum cleaner.
3.Tip out the collected mate- rial.
4.The material collected must be disposed of in accor- dance with the applicable regulations.
A | A |
5.Attach the upper section of the vacuum.
6.Close the retaining clamps
(B). Ensure that the retaining clamps fit properly.
18 | Original Instruction |