Multi Tech Equipment MVH306DSCPAS, MVH306DS2 manual Vibrator Oil Level Check, Draining Vibrator Oil

Page 26

maintenance

Vibrator Oil Level Check

NOTICE

ALWAYS clean the area around the vibrator oil level check plug before removing oil check plug. This will prevent dirt and debris from entering the system.

1.In every 100 hours of operation, with the machine positioned horizontally, use a 3/4” (19 mm) wrench and remove vibratoroil level check plug (Figure 33).Visually inspect and see if vibrator oil level is up to filler port. Be sure to clean area around check hole to prevent dirt and dust from entering.

ADD 10W-30 WT.

OILGAUGE/

MOTOR OIL

DIPSTICK

HERE

 

DRAIN

BOLT

 

OILGAUGE/

 

CORRECT

DIPSTICK

 

 

 

DRAIN

 

FILL TO 600CC

 

MAXIMUM

BOLT

EXCITER OIL LEVEL CASING NORMAL

 

 

INCORRECT

 

 

EXCITER OIL LEVEL CASING OVERFILLED

Figure 33. Vibrator Oil Drain and Check Plugs

Draining Vibrator Oil

1.Replace vibrator oil after first 200 hours and in every 1,000 hours of operation. Oil capacity is 600 cc.

2.Position handle bar vertically (storage position).

3.Using a 14 mm wrench remove the vibrator oil drain plug (Figure 33) from the vibrating plate assembly.

NOTICE

For draining oil through level check hole, have the machine inclined with a sleeper or the like placed under the compaction plate on opposite side.

4.After hydraulic oil has been completely drained from machine, fill with 10W-30 motor oil to the appropriate safe operating level (Figure 33).

5.Reinstall drain plug into vibrating plate assembly. Apply seal tape or Loctite #575 to thread portion of drain plug.

Draining Hydraulic Oil

1.Disconnect the hydraulic hose (Figure 34) connected to the hydraulic oil cylinder.

2.Push the travel lever back and forth to drain the hydraulic oil from the hand pump (hydraulic oil reservoir).

HYDRAULIC

HOSE

HYDRAULIC

CYLINDER

Figure 34. Hydraulic Oil Cylinder/Hose

3.After draining hydraulic oil, reconnect hydraulic oil hose to cylinder.

4.Place handle in upright position. Pull travel lever all the way back (reverse), and using a rope, secure travel lever to hand grip.

Adding Hydraulic Oil

1.Remove the breather cap and oil plug (Figure 35) from thehydraulic oil tank using a 24mm hex socket.

OIL

BREATHERTANK

CAP

HYDRAULIC

OIL PLUG

(24 MM WRENCH)

Figure 35. Hydraulic Oil Tank

page 26 — mvh306ds2/dsCPAs pLATE COMPACTOR • operation and parts manual — rev. #7 (02/04/14)

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Series Model MVH306DS2/ MVH306DSCPAS PROPOSITION 65 Warning Diesel engine exhaust and somePage Table of Contents Choose from three easy options Safety Information Safety MessagesGeneRaL saFeTY Engine saFeTY Before servicing equipment„ Use well-insulated gloves when picking up the battery FueL saFeTYBaTTeRY saFeTY eLeCTRiC sTaRT OnLY EmissiOns inFORmaTiOn TRanspORTing saFeTYEnviROnmenTaL saFeTY/deCOmmissiOning Emission Control LabelSpecifications YanmarDimensions DimensionsGeneral nformation Components MVH306DS2/DSCPAS Reversible Plate Compactor ComponentsBasic engine Fuel Tank Capacity is 3.5 quarts 3.31 liters of diesel fuelChecking Engine Oil Level Using a 24 mm wrench, remove the hydraulic oil filler plugBefore Starting Checking the Hydraulic Oil LevelChecking The Fuel Checking the Air CleanerLoosen the wing nut , remove the air cleaner cover Remove the fuel cap located on top of fuel tankReleasing the Handle Adjusting Handle HeightOperation Push down decompression lever and release Recoil StartMove the throttle lever to the Start position Figure If the engine does not start, repeat steps 1 thruTraveling Normal ShutdownEmergency Shutdown Push up the handle upward until the handle locks in placeNormal Compaction Compaction Limit Compaction Sensor MVH306 Dscpas OnlySystem Diagnostics to Detect Operational Abnormalities Function to Detect Electric System AbnormalityDaily Service MaintenanceInspection and Maintenance Service Tables „„Check for leakage of fuel or oilAir Filter Every 6 Months or 400 Hours Engine Oil ReplacementReinstalling the V-belt Replacing the V-beltDraining Hydraulic Oil Vibrator Oil Level CheckDraining Vibrator Oil Adding Hydraulic OilBattery Maintenance Option Adding Hydraulic OilBattery Cable Connection Option Reinstall fuel filter and connect all associated hardwareLong Term Storage Explanation of Code in Remarks Column Suggested Spare Parts Nameplates and decals Decal Caution Decal OIL SAE 10W-30Decal Model Logo MVH-306 Decal Shell Tellus OILVibrating Plate Assy Copper Packing Vibrating PlateDrain Plug Packing 1/4 CUBase and Engine Assy Belt Cover BaseEngine ASSY. L70V6 Yanmar DUST-PROOF SpongeBase and Engine Assy Guard Hook Drain JointClamp TC-100 WASHER, Lock M14Vibrator Assy Roller Bearing NJ310EMC4 Includes Items W/ #Vibrating Case Rotary SHAFT, DriveControl Handle Assy WASHER, Flat M12 Handle BracketHandle Bracket R Rubber CouplingControl Handle Assy Handle Boss COLUMN, HandleTravel Lever Handle W/GRIP RubberHand Pump Assy Control Shaft AccumlatorIncludes Items W/# BushBattery Assy CRADLE, Battery Battery Cord 400LBattery Cord + 550L Battery 55B24LCOMPACTION Analyzing System ASSY. mVH3O6DSCPAS Wire CLIP,SENSOR Wire HARNESS, SensorWire Harness Compaction Sensor PanelElectric Device Assy Buzzer EBL Wire CPHarness C, Wire Ignition KEYYanmar L70V6 Cylinder Block Assy Ring Cylinder Block AssyCylinder Head Gasket Assy Shim SETYanmar L70V6 Cylinder head Assy Exhaust Valve Adjusting ScrewIntake Valve Valve SpringYanmar L70V6 air cleaner Assy AIR Cleaner Gasket AIR Cleaner BodyAIR Cleaner Cover Wing NUTYanmar L70V6 Muffler Assy Bolt M6X14 Plated Muffler GasketMuffler Assy Stud M8X18 PlatedYanmar L70V6 Crankshaft and Camshaft Assy Roller Tappet Assy Camshaft AssyTappet Push ROD AssyYanmar L70V6 Piston Assy Piston PIN Piston Rings SET = STDPiston Ring SET OS = CirclipYanmar L70V6 LUB OIL Pump and Governor Assy LUB. OIL Pump Cover Adjusting BoltLUB. OIL Pump Assy Ring CoverYanmar L70V6 Cooling and Starting Device Assy Side Cover a Tank GrommetSide Cover B TOP COVER, BlackYanmar L70V6 Fuel Injection Pump Assy PIN Nozzle AssyNozzle NUT Nozzle SpringYanmar L70V6 Fuel Tank and Fuel Line Assy FILTER, Fuel PackingCAP Valve Pipe GuageYanmar L70V6 Starting Motor and Dynamo Assy Armature Gear Housing AssyMagnet Switch Thrust Washer KITYanmar L70V6 TOOL, LABEL, and Gasket Assy Yanmar Label HOW to START- E LabelAIR Cooled Label Diesel LabelTerms and Conditions of Sale Parts FReighT pOLiCYPage HERE’S HOW to GET Help
Top Page Image Contents