Multi Tech Equipment MVH306DSCPAS, MVH306DS2 manual Battery Cable Connection Option

Page 28

maintenance

BATTERY CHARGING

DO NOT charge battery with the battery cables connected to the compactor. The diodes will be damage by the high voltage.

Batteries generate hydrogen gas which

can be highly explosive. DO NOT smoke or allow flames or sparks near the battery, especially during charging of the battery.

Charge the battery in a open air environment (plenty of ventilation).

Before charging , remove the cap from each cell of the battery.

Connect the positive (+) lead of the charger to the positive (+) terminal of the battery and the negative (-) lead of the charger to the negative (-) terminal of the battery. DO NOT reverse the polarity when charging. Reverse polarity will damage the charger rectifier or the battery.

Battery fluid will be lost through continuous charging and discharging.

Discontinue charging if the electrolyte temperature exceeds 117° F (45° C).

NOTICE

During summer much more battery fluid is lost than in winter. Before starting, check battery electrolyte levels and replenish with distilled water to the upper mark on the battery.

BATTERY CABLE CONNECTION (Option)

1.Take off the battery cover by removing the M6 nuts that secure the battery holder to the cover.

2.When removing battery cables, disconnect the ground side (normally negative) first (Figure 39).

3.When installing battery cable connect the ground side (normally negative) last.

Figure 39. Removing Battery Cover

CHECKING FUEL FILTER

1.Clean the fuel filter every 3 months or 200 hours.

2.Replace fuel filter every 6 months or 400 hours.

3.To clean the fuel filter, loosen the nuts (Figure 40) of the fuel cock and pull out the filter from the F.O. tank filler port. Wash the filter thoroughly with diesel fuel oil.

4.Reinstall fuel filter and connect all associated hardware

DRAIN

PLUG

NUTS

page 28 — mvh306ds2/dsCPAs pLATE COMPACTOR • operation and parts manual — rev. #7 (02/04/14)

Image 28

Contents Series Model MVH306DS2/ MVH306DSCPAS PROPOSITION 65 Warning Diesel engine exhaust and somePage Table of Contents Choose from three easy options Safety Information Safety MessagesGeneRaL saFeTY Engine saFeTY Before servicing equipmentBaTTeRY saFeTY eLeCTRiC sTaRT OnLY FueL saFeTY„ Use well-insulated gloves when picking up the battery TRanspORTing saFeTY EnviROnmenTaL saFeTY/deCOmmissiOningEmissiOns inFORmaTiOn Emission Control LabelSpecifications YanmarDimensions DimensionsGeneral nformation Components MVH306DS2/DSCPAS Reversible Plate Compactor ComponentsBasic engine Fuel Tank Capacity is 3.5 quarts 3.31 liters of diesel fuelUsing a 24 mm wrench, remove the hydraulic oil filler plug Before StartingChecking Engine Oil Level Checking the Hydraulic Oil LevelChecking the Air Cleaner Loosen the wing nut , remove the air cleaner coverChecking The Fuel Remove the fuel cap located on top of fuel tankOperation Adjusting Handle HeightReleasing the Handle Recoil Start Move the throttle lever to the Start position FigurePush down decompression lever and release If the engine does not start, repeat steps 1 thruTraveling Normal ShutdownEmergency Shutdown Push up the handle upward until the handle locks in placeNormal Compaction Compaction Limit Compaction Sensor MVH306 Dscpas OnlySystem Diagnostics to Detect Operational Abnormalities Function to Detect Electric System AbnormalityMaintenance Inspection and Maintenance Service TablesDaily Service „„Check for leakage of fuel or oilEngine Oil Replacement Reinstalling the V-beltAir Filter Every 6 Months or 400 Hours Replacing the V-beltVibrator Oil Level Check Draining Vibrator OilDraining Hydraulic Oil Adding Hydraulic OilBattery Maintenance Option Adding Hydraulic OilBattery Cable Connection Option Reinstall fuel filter and connect all associated hardwareLong Term Storage Explanation of Code in Remarks Column Suggested Spare Parts Nameplates and decals Decal OIL SAE 10W-30 Decal Model Logo MVH-306Decal Caution Decal Shell Tellus OILVibrating Plate Assy Vibrating Plate Drain PlugCopper Packing Packing 1/4 CUBase and Engine Assy Base Engine ASSY. L70V6 YanmarBelt Cover DUST-PROOF SpongeBase and Engine Assy Drain Joint Clamp TC-100Guard Hook WASHER, Lock M14Vibrator Assy Includes Items W/ # Vibrating CaseRoller Bearing NJ310EMC4 Rotary SHAFT, DriveControl Handle Assy Handle Bracket Handle Bracket RWASHER, Flat M12 Rubber CouplingControl Handle Assy COLUMN, Handle Travel LeverHandle Boss Handle W/GRIP RubberHand Pump Assy Accumlator Includes Items W/#Control Shaft BushBattery Assy Battery Cord 400L Battery Cord + 550LCRADLE, Battery Battery 55B24LCOMPACTION Analyzing System ASSY. mVH3O6DSCPAS Wire HARNESS, Sensor Wire HarnessWire CLIP,SENSOR Compaction Sensor PanelElectric Device Assy Wire CP Harness C, WireBuzzer EBL Ignition KEYYanmar L70V6 Cylinder Block Assy Cylinder Block Assy Cylinder Head Gasket AssyRing Shim SETYanmar L70V6 Cylinder head Assy Adjusting Screw Intake ValveExhaust Valve Valve SpringYanmar L70V6 air cleaner Assy AIR Cleaner Body AIR Cleaner CoverAIR Cleaner Gasket Wing NUTYanmar L70V6 Muffler Assy Muffler Gasket Muffler AssyBolt M6X14 Plated Stud M8X18 PlatedYanmar L70V6 Crankshaft and Camshaft Assy Camshaft Assy TappetRoller Tappet Assy Push ROD AssyYanmar L70V6 Piston Assy Piston Rings SET = STD Piston Ring SET OS =Piston PIN CirclipYanmar L70V6 LUB OIL Pump and Governor Assy Adjusting Bolt LUB. OIL Pump AssyLUB. OIL Pump Cover Ring CoverYanmar L70V6 Cooling and Starting Device Assy Tank Grommet Side Cover BSide Cover a TOP COVER, BlackYanmar L70V6 Fuel Injection Pump Assy Nozzle Assy Nozzle NUTPIN Nozzle SpringYanmar L70V6 Fuel Tank and Fuel Line Assy Packing CAP ValveFILTER, Fuel Pipe GuageYanmar L70V6 Starting Motor and Dynamo Assy Gear Housing Assy Magnet SwitchArmature Thrust Washer KITYanmar L70V6 TOOL, LABEL, and Gasket Assy HOW to START- E Label AIR Cooled LabelYanmar Label Diesel LabelTerms and Conditions of Sale Parts FReighT pOLiCYPage HERE’S HOW to GET Help