Karcher PS640G installation manual Conveyor Installation, Do not Overtighten the Conveyor Belt

D. Conveyor Installation

1.Unfold the conveyor as shown in Figure 2-12. Then, begin to slide the conveyor into the end of the oven. The conveyor can only be installed from the end of the oven with the drive motor.

2.Continue moving the conveyor into the oven until the frame protrudes equally from each end of the oven. Check that the crumb tray supports located on the under- side of the conveyor frame rest firmly against the lower end plugs, as shown in Figure 2-13.

3.When the conveyor is positioned properly, check for freedom of movement of the conveyor belt by pulling it for about 2-3 feet (0.6-1.0m) with your fingers. The drive and idler shafts must rotate smoothly, and the belt must move freely without rubbing on the inside of the oven.

4.Check the tension of the conveyor belt as shown in Figure 2-14. The belt should lift about 1″ (25mm).

DO NOT OVERTIGHTEN THE CONVEYOR BELT.

NOTE: If necessary, the belt tension can be adjusted by turning the conveyor adjustment screws, located at the idler (non-control) end of the conveyor. See Figure 2-14.

Figure 2-12. Conveyor installation

Folded

frame

Figure 2-13. Conveyor placement

Crumb tray

support bracket

End plug

Conveyor placed in oven

Figure 2-14. Conveyor Belt tension

Idler end (with belt tension

adjustment screws)

1″ (25mm)

vertical deflection

	Adjustment
Drive end (with	screws (2) on
drive sprocket)	idler end of
	conveyor

11