S E R V I C E C A L L C H E C K
Please check the following before calling for service:
1.Place one cup of water in a glass measuring cup in the oven and close the door securely.
Operate the oven for one minute at 100% microwave power. | YES _______ |
|
A Does the oven light come on? | NO _______ | |
B Does the cooling fan work? | YES _______ | NO _______ |
(Put your hand over the rear ventilating openings.) | YES _______ |
|
C Does the turntable rotate? | NO _______ | |
(It is normal for the turntable to turn in either direction.) | YES _______ |
|
D Is the water in the oven warm? | NO _______ |
2.Remove water from the oven and operate the oven for 5 minutes at NORMAL CONVECTION 450° F.
A | Do HEAT and ON indicators light? | YES _______ | NO _______ |
B | After the oven shuts off, is inside of the oven hot? | YES _______ | NO _______ |
If “NO” is the answer to any of the above questions, please check electrical outlet, fuse and/or circuit breaker. If they are functioning properly, CONTACT YOUR NEAREST SHARP AUTHORIZED SERVICER. A microwave oven should never be serviced by a
NOTE: 1. If time appearing in the display is counting down very rapidly, check Demonstration Mode on page 27 and cancel.
2.After cooking, the cooling fan may switch on to cool the oven cavity. When the cooling fan is on, the display may show "NOW COOLING" and you will hear the sound of the cooling fan.
3.Your oven has a voltage check function. If the voltage rises above 7% or falls below 10% of the needed 208 volts, the cooking results may be unacceptable; therefore the oven automatically checks voltage at the first 5 seconds and will display a message twice if necessary. Although the oven will not interrupt the cooking program, follow the displayed message and pay attention to the food in the oven. Adjust the cooking time.
ERROR/ NORTIFICATION MESSAGE
Should any of the error/nortification messages appear in the display, follow the instructions:
Error message | Action required | |
|
| |
Thermistor failure | Call for service. You can use microwave cooking only before service. | |
|
| |
Memory failure | Call for service. The operations except for memory entry and memory | |
cooking can be used. | ||
| ||
|
| |
Maximum time exceeded | Check the maximum time of the cooking time you set. Touch STOP/CLEAR | |
| pad, and reprogram correctly. | |
|
| |
CHECK 1 | When CHECK 1 appears in the display, the average life of the magnetron | |
| has been reached. Observe microwave performance carefully and call for | |
| service when no microwave power is available. | |
|
| |
CHECK 2 | When CHECK 2 appears in the display, the average life of the top heater | |
| has been reached. When browning is decreased and cooking times | |
| increase, call for service. | |
|
| |
CHECK 3 | When CHECK 3 appears in the display, the average life of the side heater | |
| has been reached. When browning is decreased and cooking times | |
| increase, call for service. | |
|
|
30