| Title | Installation & Operation | Rev 1.00A |
|
|
|
|
| Model | EAH / EC Dishwasher | 01/26/04 |
|
|
|
|
Door Handle Conversion EC to EAH #00617.20
ITEM | NO. | P/N | DESCRIPTION | |
NO. | REQ’D | |||
|
| |||
1 | 2 | 00603.20 | Door Spring Extension Rod | |
2 | 1 | 00613.09 | Door Handle | |
3 | 1 | 00926.00 | 5/16” SS Washer | |
4 | 1 | 01555.50 | L.H. Door Handle Support | |
5 | 1 | 01556.50 | R.H. Door Handle Support | |
6 | 2 | 00607.04 | Door Handle Cap 1” | |
7 | 4 | 00924.00 | ¼” SS Washer | |
8 | 2 | 00900.00 | Cotter Pin | |
9 | 4 | 00912.00 | ¼” 20 Nylon Lock Nut | |
10 | 4 | 00962.00 | ||
11 | 1 | 00603.20 | Eye Bolt | |
12 | 2 | 01505.32 | Tray Track Inline AH |
INSTRUCTIONS:
1.Open dishmachine doors to their highest position so that there is little spring resistance on the door handle. Remove hardware holding the door handle to the door linkage. Save all the washers and spacers. With the door handle in “UP” position, lift spring and remove from extension rod. Remove the nut attaching the eyebolt and save all hardware.
2.To remove the door handle, simply unscrew the four bolts holding the door handle mounting plates and slide the complete assembly up and off of the cabinet. Use the bolts, nuts and washers to plug the holes in the back of the cabinet.
3.Remove door panel & hardware from left side of machine. Remove door guides on the front of the cabinet and mount them on left side of the machine. Remove tray track ( c ) and replace it with the track in line from the kit.
4.Using provided nuts, bolts and washers; mount the left and right door handle supports on the back of the cabinet. Insert the eyebolt into the bracket on the frame and screw the nuts on just enough to hold them in place. Hook door spring and door spring extension rod on to the door handle and secure it with the washer and cotter pin. Then simply rest the door handle on the door handle supports. (You may have to lift the door handle to reach the handle supports.)
5.Swing the door handle downwards to reach the door linkages; and using the two provided bolts and existing washers and spacers, attach the door linkages to the door handle. Adjust the tension in the spring by tightening the nuts under the eyebolt bracket so that the doors can slide up and down freely. Mount the provided door handle grips on the ends of the door handle.
6.Eyebolt adjustment nuts should be adjusted to the point the doors begin to lift from a closed position. SEE “Illustration” for the proper location of all door handle hardware included on EAH machine.
Page 17